Config: Special Commands Indicator

Hello,

Is it possible either in the current release or possibly in a future
release, to configure what the special commands indicator?  Very often
documentation contains at-signs or backslashes and while I know of the
workarounds to escape them, in some cases this becomes very tedious.

Would it be possible to add a configuration directive that allows
setting what the special commands indicator would be?  For example:

SPECIAL_CMD_INDICATOR = @@

Thank you,

---
Hans Zaunere / Managing Member / Stackware, LLC
              stackware.com   /   cnvyr.io

------------------------------------------------------------------------------
Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer
Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports
Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper
Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer
http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk