[ refdb-Bugs-1584375 ] External database link not possible

Bugs item #1584375, was opened at 2006-10-25 14:06
Message generated for change (Comment added) made by mhoenicka
You can respond by visiting: 
https://sourceforge.net/tracker/?func=detail&atid=385991&aid=1584375&group_id=26091

Please note that this message will contain a full copy of the comment thread,
including the initial issue submission, for this request,
not just the latest update.
Category: refdbd
Group: None
Status: Open
>Resolution: Works For Me
Priority: 5
Private: No
Submitted By: steletch (steletch)
Assigned to: Markus Hoenicka (mhoenicka)
Summary: External database link not possible

Initial Comment:
Unless i have not read correctly the manual, i think it
is not possible to have a separate refdb server and a
database server (be it mysql or postgresql).

It would be nice to be able to separate it since having
a separate database server would be nice (i.e. the
external database server can be on the internet and
refdbd on another machine). In fact, most providers
allow database functinalities but do not permit
software installation (refdb).

If i'm wrong, please tell me where i could correct it
please.

Cheers,

Stéphane

----------------------------------------------------------------------

>Comment By: Markus Hoenicka (mhoenicka)
Date: 2006-10-25 14:23

Message:
Logged In: YES 
user_id=85809

I'm sure that this is just a configuration problem as it was
one of the design goals to be able to separate the clients,
the application server, and the database engine physically
if you have any reasons to do so. refdbd (or rather the
libdbi driver it uses) basically acts as the database engine
client. In order to access the database engine on a
different machine, you need to tweak two refdbd settings:

- set the IP address of the box that runs your database
engine. Either set "serverip" in the refdbdrc config file,
or use the -i command line switch. Use the IP address or the
hostname if it can be resolved properly

- set the port where the database engine listens. Set
"dbsport" in refdbcrc, or use the -b command line switch
(*NOT* the more appealing -p switch which defines which port
refdbd listens on for client connections)

This should be all it takes on the RefDB side. Of course you
need to configure your database engine appropriately. E.g.
both MySQL and PostgreSQL listen to local connections only
by default for security reasons. You'll have to flip a
switch to make them serve external connections. Also, both
engines support host-based authentication. That is, you need
to set the database permissions properly to allow
connections from refdbd. It may be slightly confusing that
the host in question is the box where refdbd runs, not where
the client runs (because refdbd acts as the database engine
client, as mentioned before).


----------------------------------------------------------------------

You can respond by visiting: 
https://sourceforge.net/tracker/?func=detail&atid=385991&aid=1584375&group_id=26091

-------------------------------------------------------------------------
Using Tomcat but need to do more? Need to support web services, security?
Get stuff done quickly with pre-integrated technology to make your job easier
Download IBM WebSphere Application Server v.1.0.1 based on Apache Geronimo
http://sel.as-us.falkag.net/sel?cmd=lnk&kid=120709&bid=263057&dat=121642
_______________________________________________
Refdb-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/refdb-devel