Re: Dynamic wsdl

This is a speculation, not a definitive answer.  The ?wsdl URL is handled
by the Axis servlet, so if no other way was found, you could introduce a
servlet filter that used an XSLT, or some other technique to transform
whatever normally comes out of the ?wsdl URL.


On Thu, Apr 17, 2014 at 7:18 AM, Andrea Cappelli <[email protected]>wrote:

>  Il 17/04/2014 15:28, Martin Gainty ha scritto:
>
>
> MG>Port Address translation or PAT is explained at
> MG>http://www.dslreports.com/faq/13449
>
>
> I know what PAT is, but seems to me that it ha nothing to do with the
> matter of this thread
>
>
>  MG>Cisco has ASA-5500 ADSM Product which will configure NAT/PAT for IP
> access outside of your DMZ
> MG>
> http://www.cisco.com/c/en/us/td/docs/security/asa/asa83/asdm63/configuration_guide/config/public_servers.html
>
>
>
> Except that I don't have any Cisco product (only Linux VM), I don't
> understand how this is related to my question.
>
> I only need to now if there are some configurations that let me change
> protocol and port used inside WSDL in a dynamic way
>
> Best regards
>
> --
> Andrea Cappelli
>
>