Re: Start parameter in MIFFY/MTOM

[email protected]
Newsgroups gmane.text.xml.distributed
Message-ID <[email protected]>
Should the HTTP binding make that a MUST to indicate the root part for 
SOAP/MTOM over HTTP?   Not sure, just asking.

--------------------------------------
Noah Mendelsohn 
IBM Corporation
One Rogers Street
Cambridge, MA 02142
1-617-693-4036
--------------------------------------








Mark Nottingham <[email protected]>
Sent by: [email protected]
01/14/04 09:33 AM

 
        To:     "Herve Ruellan" <[email protected]>
        cc:     XMLP Dist App <[email protected]>, (bcc: Noah Mendelsohn/Cambridge/IBM)
        Subject:        Re: Start parameter in MIFFY/MTOM



Perhaps something like;

"""Note that MIFFY Packages using Multipart/Related may use any of the 
facilities therein, including the start parameter to indicate the root 
part."""



On Jan 14, 2004, at 7:03 AM, Herve Ruellan wrote:

> I would like to make sure that all MIFFY or MTOM implementations 
> supporting Multipart/Related packages have to support the "Start" 
> parameter.
> From reading between the lines of the last MIFFY spec [1], I think 
> this is the case, but I would prefer if it was explicitely said in 
> section 2.1.
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.