| Newsgroups |
gmane.text.xml.distributed |
| Message-ID |
<[email protected]> |
To clarify, I meant that in HTTP it should be a MUST if the SOAP envelope
is not the first part. That's also consistent, BTW, with the WS-I
attachment profile draft [1] (section 3.1.8).
[1] http://www.ws-i.org/Profiles/Basic/2003-08/AttachmentsProfile-1.0.htm
--------------------------------------
Noah Mendelsohn
IBM Corporation
One Rogers Street
Cambridge, MA 02142
1-617-693-4036
--------------------------------------
Noah Mendelsohn
01/14/04 10:24 AM
To: Mark Nottingham <[email protected]>
cc: "Herve Ruellan" <[email protected]>, XMLP Dist App
<[email protected]>
Subject: Re: Start parameter in MIFFY/MTOM
Should the HTTP binding make that a MUST to indicate the root part for
SOAP/MTOM over HTTP? Not sure, just asking.
--------------------------------------
Noah Mendelsohn
IBM Corporation
One Rogers Street
Cambridge, MA 02142
1-617-693-4036
--------------------------------------
Mark Nottingham <[email protected]>
Sent by: [email protected]
01/14/04 09:33 AM
To: "Herve Ruellan" <[email protected]>
cc: XMLP Dist App <[email protected]>, (bcc: Noah
Mendelsohn/Cambridge/IBM)
Subject: Re: Start parameter in MIFFY/MTOM
Perhaps something like;
"""Note that MIFFY Packages using Multipart/Related may use any of the
facilities therein, including the start parameter to indicate the root
part."""
On Jan 14, 2004, at 7:03 AM, Herve Ruellan wrote:
> I would like to make sure that all MIFFY or MTOM implementations
> supporting Multipart/Related packages have to support the "Start"
> parameter.
> From reading between the lines of the last MIFFY spec [1], I think
> this is the case, but I would prefer if it was explicitely said in
> section 2.1.