RE: Scaling image problem

Thanks for the feedback !

But I do not know the width since it is not always the same image.

I also  tried scale-down-to-fit but could not get it to work.

BTW: I am using fop 2.2

-----Original Message-----
From: Terence M. Bandoian [mailto:[email protected]] 
Sent: woensdag, oktober 11, 2017 17:24
To: [email protected]
Subject: Re: Scaling image problem

On 10/11/2017 9:39 AM, Beugnier, Ronny (IP&Science) wrote:
>
> Hi,
>
> I am looking for a way that an image scales to fit the page. I have 
> tried various solutions but non worked.
>
> The image on the page is too big to fit the page so it is not shown 
> entirely. How can I scale in fop to see the full image on the image ?
>
> Many Thanks !
>
> Ronny
>
>

Hi, Ronny-

In my case, I was able set the width (only the width) of the <fo:external-graphic> element to a value in inches.

-Terence Bandoian
  http://www.tmbsw.com/


---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]