RE: diagnostics use.

Hi Edvard.

    Your code looks ok so the most likely problem is that you 
    use a schematron engine stylesheet that doesn't support 
    diagnostics. The schematron-report.xsl engine supports 
    diagnostics without modifications and I think 
    schematron-message.xsl does as well.
    However the schematron-basic.xsl does not support 
    diagnostics without some modifications.

Which matches what I found.

    I've attached a 
    schematron-diagnose.xsl engine that basically is the same 
    as schematron-basic.xsl but with support for diagnostics.

Many thanks Eddie.
    I'll try this one.
regards DaveP


** snip here **

- 
DISCLAIMER: 

NOTICE: The information contained in this email and any attachments is 
confidential and may be privileged. If you are not the intended 
recipient you should not use, disclose, distribute or copy any of the 
content of it or of any attachment; you are requested to notify the 
sender immediately of your receipt of the email and then to delete it 
and any attachments from your system. 

RNIB endeavours to ensure that emails and any attachments generated by 
its staff are free from viruses or other contaminants. However, it 
cannot accept any responsibility for any  such which are transmitted.
We therefore recommend you scan all attachments. 

Please note that the statements and views expressed in this email and 
any attachments are those of the author and do not necessarily represent 
those of RNIB. 

RNIB Registered Charity Number: 226227 

Website: http://www.rnib.org.uk 


-------------------------------------------------------
The SF.Net email is sponsored by EclipseCon 2004
Premiere Conference on Open Tools Development and Integration
See the breadth of Eclipse activity. February 3-5 in Anaheim, CA.
http://www.eclipsecon.org/osdn