Unable to activate ethernet card in zenwalk linux
WebMaster <[email protected]>
| Newsgroups | gmane.user-groups.linux.kolkata |
|---|---|
| Message-ID | <[email protected]> |
Hi all, Today I have installed zenwalk on a Pentium IV system with 128 MB RAM and Intex RTL8139D ethernet card. Now in order to configure my ethernet card when I am using netconfig command then I am setting following values for the parameters asked: Hostname: zenwalk Domain: org Network Type: Static IP Address IP Address: 192.168.0.4 Subnet Mask: 255.255.255.0 Gateway: None Nameserver: None Then I am getting message that a network card using the 3c59x.o module has been detected. Then I am accepting the configuration. Thereafter I am getting the message "Setting Accepted: Basic network configuration is complete". But after then when I am executing the "ifconfig" command then I am not seeing the name of eth0 in the list of network devices. And I am also not able to ping my other systems in LAN. When I am executing the ping command then I am getting the message "Network is unreachable". So please help me by telling how to activate the device eth0 in zenwalk linux when my network card has already been detected with the module 3c59x.o. I will remain thankful to all those of you for this forever. Best Regards ... Pankaj Kumar _______________________________________________ Ilug-cal-discuss mailing list Ilug-cal-discuss-PMNjqutUrVNkNBGiPgg+Odi2O/[email protected] http://list.ilug-cal.org/mailman/listinfo/ilug-cal-discuss