Variables used in the RHEL config files and init scripts
Arun Khan <[email protected]>
| Newsgroups | gmane.user-groups.linux.delhi,gmane.org.user-groups.linux.plug,gmane.user-groups.linux.mumbai |
|---|---|
| Message-ID | <CAHhM8gCG6LvrpYnuT4_9PxBrNYYw7DT7RixKwW5vvXaBnezYnw@mail.gmail.com> |
Have you ever been frustrated trying to find *all* the possible variables used in the config files and init scripts in a RHEL or derivative distribution? I was working on a RHEL setup to configure a "dummy0" interface with very specific requirement: this interface shall *not* be managed by the NetworkManager. The RHEL Networking PDF (official doc) does not mention NM_CONTROLLED! After much searching, I found the answer in this Ars Technica discussion forum https://arstechnica.com/civis/viewtopic.php?t=767128 They are all defined in a file that goes by the following name. /usr/share/doc/initscripts-xxx/sysconfig.txt (where xxx is the initscripts version installed by the distro) I hope you find it useful in your journey as a Sys/Net Admin working with RHEL and/or derivative. Cheers, -- akk _______________________________________________ Ilugd mailing list [email protected] https://lists.hserus.net/mailman/listinfo/ilugd