Re: ip assignment in /28 netblock & routing

Can this answer your question?
http://www.dmzinabox.com/support/faqs/showfaq.php?item=Should%20I%20use%20public%20or%20private%20IP%20addresses%20in%20the%20DMZ%20security%20zone


On 17 May 2010 14:59, M K Saravanan <[email protected]> wrote:
> Hi,
> Need help on setting up firewall router (using vyatta community edition).
>  My config is as below:
> Public static network ID: x.x.x.48/28
> gateway: x.x.x.49
> available IP for the hosts: x.x.x.52 to 62
>
> gw_eth0 <--> fw_eth0 - fw_eth1 <--> dmz_switch
> Four servers are connected on dmz_switch (say s1, s2, s3, s4) all have to
> use public static IP address from the above block.
> Any recommendation on IP assignment and route setup?  Do I need to subnet
> the above block further or simply use /32 netmask and point-to-point static
> routes in the above setup?
>
> with regards,
> mks
>
> _______________________________________________
> LUGS Mailing list - [email protected]
> List FAQ: http://wiki.lugs.org.sg/LugsMailingListFaq
> Info page: http://www.lugs.org.sg/mailman/listinfo/slugnet
> To unsubscribe send an empty email to: [email protected]
>
>

_______________________________________________
LUGS Mailing list - [email protected]
List FAQ: http://wiki.lugs.org.sg/LugsMailingListFaq
Info page: http://www.lugs.org.sg/mailman/listinfo/slugnet
To unsubscribe send an empty email to: [email protected]