Re: bash script not working properly

I'll bite.

I notice you use capture.pcapng in Moveit.sh.  How about fully qualifying
the path with /home/raymond/capture.pcapng?

Are you getting an error message from the failure?  If so what is that
error?



On Wed, Oct 23, 2019 at 12:48 PM <[email protected]> wrote:
>
> I have a simple bash script (ws.sh), with the following 2 commands:
>
> #!/bin/bash
>
> tshark -i enp1s0 -a duration:60 -w /home/raymond/capture.pcapng
>
> wait
>
> /home/raymond/movit.sh
>
> Movit.sh:
>
>
> #!/bin/bash
> mv capture.pcapng $(date +%F-%H:%M)1.pcapng && touch capture.pcapng
> echo "All Done!"
>
> The first command always works properly but the second does not run via
cron. However, running the script (ws,sh) via the command line executes
properly. I have tried  sleep and wait between commands but nothing works,
so far.
>
> Ideas?
>
>
>
> Raymond Norton
> LCTN
> 952.955.7766
> _______________________________________________
> TCLUG Mailing List - Minneapolis/St. Paul, Minnesota
> [email protected]
> http://mailman.mn-linux.org/mailman/listinfo/tclug-list

_______________________________________________
TCLUG Mailing List - Minneapolis/St. Paul, Minnesota
[email protected]
http://mailman.mn-linux.org/mailman/listinfo/tclug-list