Re: Firewall distros.. What do the cool kids use now?

Business class routers will ignore this but still let you use the origination IP (like the 100.1) as part of the routing table. My old Netgear, which I defaulted and left with my ex when we split, had that IP and I still got the outside IP on my firewall for routing. I could call up the firewall webpage at any time using the internal IP but it was never part of my network design.


> On Apr 26, 2020, at 9:09 PM, Joseph Key <[email protected]> wrote:
> 
> My cable gateway uses 192.168.100.1 as the gateway address
> 
> On 4/26/2020 11:58 AM, Brian Wood wrote:
>> r hayman writes:
>> > and after putting the Comcast modem in bridge mode,  
>> 
>> I put my cable gateway into bridge mode recently.  
>> I had trouble though disabling bridge mode.    I had 
>> an ethernet cable connected between my laptop and 
>> the modem, but couldn't figure out what address 
>> would work to get to the modem's interface.  I tried 
>> 192.168.0.1, 10.0.0.1 and my laptop's IP4 address 
>> but with .1 replacing what my IP address ended in.  
>> None of that worked.  So I did a hard reset of the
>> modem.   Anyone know what to try next time?  Tia
>> 
>> 
>> Brian
>> Ebenezer Enterprises - In G-d we trust.
>> https://github.com/Ebenezer-group/onwards <https://github.com/Ebenezer-group/onwards>  
>> 
>> 
>> _______________________________________________
>> TCLUG Mailing List - Minneapolis/St. Paul, Minnesota
>> [email protected] <mailto:[email protected]>
>> http://mailman.mn-linux.org/mailman/listinfo/tclug-list <http://mailman.mn-linux.org/mailman/listinfo/tclug-list>
> _______________________________________________
> TCLUG Mailing List - Minneapolis/St. Paul, Minnesota
> [email protected]
> http://mailman.mn-linux.org/mailman/listinfo/tclug-list

_______________________________________________
TCLUG Mailing List - Minneapolis/St. Paul, Minnesota
[email protected]
http://mailman.mn-linux.org/mailman/listinfo/tclug-list