Re: Computer turns on and then just dies

s|b <[email protected]> wrote:

> On Sat, 23 Nov 2024 14:28:54 -0600, VanguardLH wrote:
> 
>> Here's another guy gobbing
>> on way too much thermal paste: https://youtu.be/a0LlMDk_ljQ?t=12.
> 
> This guy is doing a lot better, I think:
> <https://youtu.be/eyNTXDoLyEU?feature=shared>
> 
> I don't think my MX-4 comes with a spatula, but I've cut 1/3 of a
> plastic card which I'll be using.

The "card" should be thin and pliable.  The spatula is okay, but I
prefer a piece of a mylar sheet.  The amount the YT author used is the
right amount.  I apply until the layer is just translucent, and then
twist the HSF onto the CPU plate while pressing down.  Then I remove to
gauge my result.  I have to clean the HSF and CPU again, and do new
paste while making an adjustment if my prior effort deficient.  Unless
you are building computers, and need to save on the paste, even a tiny
tube gives you 5 to 10 applications, or more, which is plenty to get it
right for just one setup.  You're not gluing the HSF to the CPU, so you
can repeat until you get it right.