Re: Computer turns on and then just dies

On Tue, 26 Nov 2024 16:37:21 -0600, VanguardLH wrote:

> The "card" should be thin and pliable.  The spatula is okay, but I
> prefer a piece of a mylar sheet.  The amount the YT author used is the
> right amount.  I apply until the layer is just translucent, and then
> twist the HSF onto the CPU plate while pressing down.  Then I remove to
> gauge my result.  I have to clean the HSF and CPU again, and do new
> paste while making an adjustment if my prior effort deficient.  Unless
> you are building computers, and need to save on the paste, even a tiny
> tube gives you 5 to 10 applications, or more, which is plenty to get it
> right for just one setup.  You're not gluing the HSF to the CPU, so you
> can repeat until you get it right.

I practiced a bit and then just went ahead. I thought it went pretty
good, but... as you and Paul already stated: this isn't what causing the
problem.

I just read Paul's reaction and apparently I forgot to mention the video
card.

-- 
s|b