E64 extlinux
Thomas Zweifel <[email protected]>
| Newsgroups | spline.eisfair.dev |
|---|---|
| Organization | spline |
| Message-ID | <[email protected]> |
Hallo Eisfair-Team
Nach dem ersetzen einer Platte und anschliessendem Drüberinstallieren
vom extlinux Paket purzeln ein paar Fehlermeldungen heraus.
Downloading required packages ...
=> [####################] extlinux (3.2.0)...
[ OK ]
Done!
Installation of: extlinux (3.2.0) ...
/sys/class/block/md1/slaves/sda1/uevent: line 7: RAID: command not found
/sys/class/block/md1/slaves/sdb1/uevent: line 7: RAID: command not found
/sys/class/block/md1/slaves/sdc1/uevent: line 7: RAID: command not found
/sys/class/block/md1/slaves/sdd1/uevent: line 7: RAID: command not found
Attribute Legacy Bios Bootable Set - /dev/sda1
Attribute Legacy Bios Bootable Set - /dev/sdb1
Attribute Legacy Bios Bootable Set - /dev/sdc1
Attribute Legacy Bios Bootable Set - /dev/sdd1
Installed MBR (/tmp/extlinux/gptmbr.bin) to /dev/sda
Installed MBR (/tmp/extlinux/gptmbr.bin) to /dev/sdb
Installed MBR (/tmp/extlinux/gptmbr.bin) to /dev/sdc
Installed MBR (/tmp/extlinux/gptmbr.bin) to /dev/sdd
Detected RAID on /boot - update EXTlinux with --raid
Successfully installed: extlinux (3.2.0)!
Press ENTER to continue
md1 : active raid1 sda1[0] sdd1[2] sdc1[3] sdb1[1]
65472 blocks [4/4] [UUUU]
bitmap: 0/1 pages [0KB], 65536KB chunk
Der anschliessende Reboot funktioniert einwandfrei, dürfte somit kein
ernstes Problem sein.
Gruss Thomas