apache2 nach Update tot...

Hallo Entwickler,

barbrady # eisman upgrade
                                                  
The following packages will be installed:
 
version  status   name                   source
---------------------------------------------------------------------
3.4.6    stable   apache2                https://www.pack-eis.de
 
1 package(s) using approx. 1 MB of disk space.
 
Continue (y/n) [yes]? 
Downloading required packages ...
=> [####################] apache2 (3.4.6)...
                                       [  OK  ] Done!
Installation of: apache2 (3.4.6) ...
 * Stopping The Apache HTTP Server ...
                                       [  OK  ]
 * Stopping Disk Cache Cleaning Daemon for Apache HTTP Server ...
                                       [  OK  ] Creating Apache2
configuration ... activating modules...
done activating modules
 * Starting Disk Cache Cleaning Daemon for Apache HTTP Server ...
                                       [  OK  ]
 * Starting The Apache HTTP Server ...
Job for apache2.service failed because the control process exited with
error code. See "systemctl status apache2.service" and "journalctl -xeu
apache2.service" for details.                      [ FAIL ]
Successfully installed: apache2 (3.4.6)! barbrady # 

-----

barbrady # journalctl -xeu apache2.service
░░ A start job for unit apache2.service has begun execution.
░░ 
░░ The job identifier is 14163.
Jul 04 17:43:53 barbrady apachectl[18142]: AH00526: Syntax error on
line 24 of /etc/apache2/server-tuning.conf: Jul 04 17:43:53 barbrady
apachectl[18142]: Invalid command 'axConnectionsPerChild', perhaps
misspelled or defined by a > Jul 04 17:43:53 barbrady apachectl[18139]:
Action 'start' failed. Jul 04 17:43:53 barbrady apachectl[18139]: The
Apache error log may have more information. Jul 04 17:43:53 barbrady
systemd[1]: apache2.service: Control process exited, code=exited,
status=1/FAILURE ░░ Subject: Unit process exited ░░ Defined-By: systemd
░░ Support:
https://lists.freedesktop.org/mailman/listinfo/systemd-devel ░░ ░░ An
ExecStart= process belonging to unit apache2.service has exited. ░░ 
░░ The process' exit code is 'exited' and its exit status is 1.
Jul 04 17:43:53 barbrady systemd[1]: apache2.service: Failed with
result 'exit-code'. ░░ Subject: Unit failed
░░ Defined-By: systemd
░░ Support: https://lists.freedesktop.org/mailman/listinfo/systemd-devel
░░ 
░░ The unit apache2.service has entered the 'failed' state with result
'exit-code'. Jul 04 17:43:53 barbrady systemd[1]: Failed to start The
Apache HTTP Server. ░░ Subject: A start job for unit apache2.service
has failed ░░ Defined-By: systemd
░░ Support: https://lists.freedesktop.org/mailman/listinfo/systemd-devel
░░ 
░░ A start job for unit apache2.service has finished with a failure.
░░ 
░░ The job identifier is 14163 and the job result is failed.

Wie kriege ich den Indianer wieder ans laufen?

achso: e1

Groetjes
Stefan