Re: Probleme mit bind9

Hallo Wilhelm

wenn keine IP angegeben ist, gibt es auch nichts zum Auswaehlen

Holger

Am 20.07.26 um 09:10 schrieb Kulzer, Wilhelm:

> In der Base habe ich die neuen NIC-Namen enx002590xxxxxx entsprechend
> geändert. Nach einem neustart waren auch alle damit sofort UP.
> 
>   > Kannst du bitte mal die Netzwerkkonfiguration der Base posten?
> 
> Hier die Eth-Konfiguration aus der base:
> 
> IP_ETH_N='3'                           # number of ip ethernet networks
> 
> #------------------------------------------------------------------------------
> # Ether networks card settings:
> #------------------------------------------------------------------------------
> 
> IP_ETH_1_NAME='enx00259079d338'        # optional: other device name
> than enx*
> IP_ETH_1_MACADDR=''                    # Mac address of your n'th
> ethernet card
> 
> #------------------------------------------------------------------------------
> # Ether networks IPv4 settings:
> #------------------------------------------------------------------------------
> 
> IP_ETH_1_V4_DHCP='no'                  # Use dhcp of this device
>                                          # Use: yes or no
> IP_ETH_1_V4_METHOD='manual'            # Use: manual, link-local or disabled
> IP_ETH_1_V4_IP_N='1'                   # number of ip on network card
> IP_ETH_1_V4_IP_1_IPADDR='192.168.128.122'
> #------------------------------------------------------------------------------
> 
> IP_ETH_2_NAME='enx00259079d339'
> IP_ETH_2_MACADDR=''
> 
> 
> #------------------------------------------------------------------------------
> # Ether networks IPv4 settings:
> #------------------------------------------------------------------------------
> 
> IP_ETH_2_V4_DHCP='no'
> IP_ETH_2_V4_METHOD='manual'
> IP_ETH_2_V4_IP_N='0'
------------------------------
> 
> IP_ETH_3_NAME='enx00259079d33a'
> IP_ETH_3_MACADDR=''
> 
> #------------------------------------------------------------------------------
> # Ether networks IPv4 settings:
> #------------------------------------------------------------------------------
> 
> IP_ETH_3_V4_DHCP='no'
> IP_ETH_3_V4_METHOD='manual'
> IP_ETH_3_V4_IP_N='0'

> 
> Gruß,
> Wilhelm
> 
> 
> 
>