EisxenRC5 - Problem mit Fli4l-domU

Wieland Große <[email protected]>
Newsgroups spline.eisxen
Organization spline
Message-ID <[email protected]>
Hallo,
ich habe auf dem Eisxen RC5 eine neue fli4l-domU (3.4.0) eingerichtet.  
Beim Starten kommt es zu folgenden Fehlern:

init started: BusyBox v1.11.1 (2008-09-22 14:51:55 EDST)
Creating device nodes...
bootlogd: cannot deduce real console device
rootfs on / type rootfs (rw)
tmpfs on / type tmpfs (rw)
proc on /proc type proc (rw)
devpts on /dev/pts type devpts (rw)
-> basic setup for booting... (/etc/boot.d/rc000.base)
    Wrapping of modutils disabled ()
-> finished basic setup for booting... (/etc/boot.d/rc000.base)
-> loading disk drivers ... (/etc/boot.d/rc010.hddrv)
sh: 02.6.20-fli4l: bad number
-> finished loading disk drivers ... (/etc/boot.d/rc010.hddrv)
-> mounting boot device ... (/etc/boot.d/rc100.hdboot)
ERR: unable to mount boot partition , available partitions:
ERR: major minor  #blocks  name
ERR:
ERR: can't mount boot-partition, check partitions and drivers
BusyBox v1.11.1 (2008-09-22 14:51:55 EDST) built-in shell (ash)
Enter 'help' for a list of built-in commands.
/bin/sh: can't access tty; job control turned off

Es war früher schon mal eine funktionierender fli4l vorhanden, die später  
gelöscht wurde. Kann es sein, dass da noch irgendwo Reste geblieben sind?
Habe die Installation mehrfach wiedrholt, mit dem selben  Ergebnis.
Was kann ich tun, um das Problem zu beheben?

Danke für die Hilfe.
Wieland
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.