Re: Neue fli4l Testversionen, Webseitenzugriff

Hallo zusammen,

und wieder gibt es wieder einen neuen Build 😉

Changelog:

wlan_ng: revamp cgi qrcode, some more cosmetics
wlan_ng: include hostapd_cli and extend AP/VAP to each have its own 
socket, add Start/Stop BUtton for main AP in cgi, readd qrcode, some 
more cosmetics
wlan_ng: revamp initialization logic to get all APs/VAPs relly going
wlan_ng: adapt example config.txt to neutral settings
wlan_ng: change example config with new notations
wlan_ng: add changes file with the right name
wlan_ng: adapt example config.txt to new settings and explanations
wlan_ng: correct type in files.txt
wlan_ng: bind WLANs by MAC, add runtime editor with safe backups and 
station details
httpd: sanitize bootlog download file output but leave web dsiplay 
untouched
wlan_ng: change labels in web UI to be less technical
wlan_ng: web UI frequency band recognition fixed
wlan_ng: refine web UI controls/export and tighten bridge validation 
Improve the runtime web UI by translating AP/VAP warning messages, keeping
master/VAP control behavior aligned with the actual hostapd/VAP model, and
warning clearly when master AP or VAP actions affect other APs on the same
radio.

Generate a complete wlan_ng.txt export from runtime hostapd/wpa_supplicant
state instead of exporting only partial AP values, preserving key AP/VAP and
client settings including security, PMF, band, channel, channel width,
hidden SSID, AP isolation, bridge, scan_ssid, BSSID, and disabled state
where detectable.

Also tighten wlan_ng configuration validation so WLAN_NG_x_BRIDGE must match
an existing BRIDGE_DEV_%_DEVNAME when OPT_BRIDGE_DEV is enabled, replacing
the previous warning-only behavior.

httpd: sanitize bootlog download file output
Bump Kernel to 6.18.32 and 7.0.9
go back by hostapd to original buildroot setup as changes be not need
Disable Out of the Tree Driver for 8812au Realtek cards as the 
rtw88_8812au should be used for it
webui: polish wlan_ng runtime config UI and export Fixes and refines the 
wlan_ng web UI by improving CONFIG form alignment,
restoring QR rendering, switching daemon controls to colored Start/Stop
buttons, fixing AP editability detection, and exporting all AP/VAP entries
as wlan_ng.txt with WLAN_NG_N placed before the generated definitions.

wlan_ng: add VAP support for AP mode Add master/slave AP configuration 
with WLAN_NG_%_MASTER_DEV, allow derived VAP device names such as 
wlan0_guest, extend validation and example config, create VAP interfaces 
dynamically, generate hostapd multi-BSS configs, and assign 
deterministic unique MAC/BSSID values for VAPs. Verified on ath10k 
hardware with one main AP and one guest VAP on the same channel.

Der Download ist an der üblichen Stelle zu finden:

https://www.fli4l.de/doku.php?id=fli4l:download:developerversion:start#entwicklerversion_41

Gruß
Harvey