RE: [外部邮件] Re: [PATCH][v3] hung_task: Panic after fixed number of hung tasks
"Li,Rongqing" <[email protected]> Tue, 14 Oct 2025 05:33:07 +0000
| Newsgroups | com.zx2c4.lists.wireguard,org.ozlabs.lists.linux-aspeed |
|---|---|
| Message-ID | <[email protected]> |
> > I noticed the implementation panics only when N tasks are detected within a > single scan, because total_hung_task is reset for each > check_hung_uninterruptible_tasks() run. > > So some suggestions to align the documentation with the code's behavior > below :) > True, I will change the comments as your suggestion, thanks -Li > On 2025/10/12 19:50, lirongqing wrote: > > From: Li RongQing <[email protected]> > > > > Currently, when 'hung_task_panic' is enabled, the kernel panics > > immediately upon detecting the first hung task. However, some hung > > tasks are transient and the system can recover, while others are > > persistent and may accumulate progressively. > > > > This patch extends the 'hung_task_panic' sysctl to allow specifying > > the number of hung tasks that must be detected before triggering a > > kernel panic. This provides finer control for environments where > > transient hangs may occur but persistent hangs should still be fatal. > > > > The sysctl can be set to: > > - 0: disabled (never panic) > > - 1: original behavior (panic on first hung task) > > - N: panic when N hung tasks are detected > > > > This maintains backward compatibility while providing more flexibility > > for handling different hang scenarios. > > > > Signed-off-by: Li RongQing <[email protected]> > > --- > > Diff with v2: not add new sysctl, extend hung_task_panic > > > > Documentation/admin-guide/kernel-parameters.txt | 20 > +++++++++++++------- > > Documentation/admin-guide/sysctl/kernel.rst | 3 ++- > > arch/arm/configs/aspeed_g5_defconfig | 2 +- > > kernel/configs/debug.config | 2 +- > > kernel/hung_task.c | 16 > +++++++++++----- > > lib/Kconfig.debug | 10 > ++++++---- > > tools/testing/selftests/wireguard/qemu/kernel.config | 2 +- > > 7 files changed, 35 insertions(+), 20 deletions(-) > > > > diff --git a/Documentation/admin-guide/kernel-parameters.txt > > b/Documentation/admin-guide/kernel-parameters.txt > > index a51ab46..7d9a8ee 100644 > > --- a/Documentation/admin-guide/kernel-parameters.txt > > +++ b/Documentation/admin-guide/kernel-parameters.txt > > @@ -1992,14 +1992,20 @@ > > the added memory block itself do not be affected. > > > > hung_task_panic= > > - [KNL] Should the hung task detector generate panics. > > - Format: 0 | 1 > > + [KNL] Number of hung tasks to trigger kernel panic. > > + Format: <int> > > + > > + Set this to the number of hung tasks that must be > > + detected before triggering a kernel panic. > > + > > + 0: don't panic > > + 1: panic immediately on first hung task > > + N: panic after N hung tasks are detect > > The description should be more specific :) > > N: panic after N hung tasks are detected in a single scan > > Would it be better and cleaner? > > > > > - A value of 1 instructs the kernel to panic when a > > - hung task is detected. The default value is controlled > > - by the CONFIG_BOOTPARAM_HUNG_TASK_PANIC build-time > > - option. The value selected by this boot parameter can > > - be changed later by the kernel.hung_task_panic sysctl. > > + The default value is controlled by the > > + CONFIG_BOOTPARAM_HUNG_TASK_PANIC build-time option. > The value > > + selected by this boot parameter can be changed later by the > > + kernel.hung_task_panic sysctl. > > > > hvc_iucv= [S390] Number of z/VM IUCV hypervisor console > (HVC) > > terminal devices. Valid values: 0..8 diff --git > > a/Documentation/admin-guide/sysctl/kernel.rst > > b/Documentation/admin-guide/sysctl/kernel.rst > > index f3ee807..0a8dfab 100644 > > --- a/Documentation/admin-guide/sysctl/kernel.rst > > +++ b/Documentation/admin-guide/sysctl/kernel.rst > > @@ -397,7 +397,8 @@ a hung task is detected. > > hung_task_panic > > =============== > > > > -Controls the kernel's behavior when a hung task is detected. > > +When set to a non-zero value, a kernel panic will be triggered if the > > +number of detected hung tasks reaches this value > > Hmm... that is also ambiguous ... > > +When set to a non-zero value, a kernel panic will be triggered if the > +number of hung tasks found during a single scan reaches this value. > > > This file shows up if ``CONFIG_DETECT_HUNG_TASK`` is enabled. > > > > = ================================================= > > diff --git a/arch/arm/configs/aspeed_g5_defconfig > > b/arch/arm/configs/aspeed_g5_defconfig > > index 61cee1e..c3b0d5f 100644 > > --- a/arch/arm/configs/aspeed_g5_defconfig > > +++ b/arch/arm/configs/aspeed_g5_defconfig > > @@ -308,7 +308,7 @@ CONFIG_PANIC_ON_OOPS=y > > CONFIG_PANIC_TIMEOUT=-1 > > CONFIG_SOFTLOCKUP_DETECTOR=y > > CONFIG_BOOTPARAM_SOFTLOCKUP_PANIC=y > > -CONFIG_BOOTPARAM_HUNG_TASK_PANIC=y > > +CONFIG_BOOTPARAM_HUNG_TASK_PANIC=1 > > CONFIG_WQ_WATCHDOG=y > > # CONFIG_SCHED_DEBUG is not set > > CONFIG_FUNCTION_TRACER=y > > diff --git a/kernel/configs/debug.config b/kernel/configs/debug.config > > index e81327d..9f6ab7d 100644 > > --- a/kernel/configs/debug.config > > +++ b/kernel/configs/debug.config > > @@ -83,7 +83,7 @@ CONFIG_SLUB_DEBUG_ON=y > > # > > # Debug Oops, Lockups and Hangs > > # > > -# CONFIG_BOOTPARAM_HUNG_TASK_PANIC is not set > > +CONFIG_BOOTPARAM_HUNG_TASK_PANIC=0 > > # CONFIG_BOOTPARAM_SOFTLOCKUP_PANIC is not set > > CONFIG_DEBUG_ATOMIC_SLEEP=y > > CONFIG_DETECT_HUNG_TASK=y > > diff --git a/kernel/hung_task.c b/kernel/hung_task.c index > > b2c1f14..3929ed9 100644 > > --- a/kernel/hung_task.c > > +++ b/kernel/hung_task.c > > @@ -81,7 +81,7 @@ static unsigned int __read_mostly > sysctl_hung_task_all_cpu_backtrace; > > * hung task is detected: > > */ > > static unsigned int __read_mostly sysctl_hung_task_panic = > > - IS_ENABLED(CONFIG_BOOTPARAM_HUNG_TASK_PANIC); > > + CONFIG_BOOTPARAM_HUNG_TASK_PANIC; > > > > static int > > hung_task_panic(struct notifier_block *this, unsigned long event, > > void *ptr) @@ -218,8 +218,11 @@ static inline void > debug_show_blocker(struct task_struct *task, unsigned long ti > > } > > #endif > > > > -static void check_hung_task(struct task_struct *t, unsigned long > > timeout) > > +static void check_hung_task(struct task_struct *t, unsigned long timeout, > > + unsigned long prev_detect_count) > > { > > + unsigned long total_hung_task; > > + > > if (!task_is_hung(t, timeout)) > > return; > > > > @@ -229,9 +232,11 @@ static void check_hung_task(struct task_struct *t, > unsigned long timeout) > > */ > > sysctl_hung_task_detect_count++; > > > > + total_hung_task = sysctl_hung_task_detect_count - prev_detect_count; > > trace_sched_process_hang(t); > > > > - if (sysctl_hung_task_panic) { > > + if (sysctl_hung_task_panic && > > + (total_hung_task >= sysctl_hung_task_panic)) { > > console_verbose(); > > hung_task_show_lock = true; > > hung_task_call_panic = true; > > @@ -300,6 +305,7 @@ static void > check_hung_uninterruptible_tasks(unsigned long timeout) > > int max_count = sysctl_hung_task_check_count; > > unsigned long last_break = jiffies; > > struct task_struct *g, *t; > > + unsigned long prev_detect_count = sysctl_hung_task_detect_count; > > > > /* > > * If the system crashed already then all bets are off, @@ -320,7 > > +326,7 @@ static void check_hung_uninterruptible_tasks(unsigned long > timeout) > > last_break = jiffies; > > } > > > > - check_hung_task(t, timeout); > > + check_hung_task(t, timeout, prev_detect_count); > > } > > unlock: > > rcu_read_unlock(); > > @@ -389,7 +395,7 @@ static const struct ctl_table hung_task_sysctls[] = { > > .mode = 0644, > > .proc_handler = proc_dointvec_minmax, > > .extra1 = SYSCTL_ZERO, > > - .extra2 = SYSCTL_ONE, > > + .extra2 = SYSCTL_INT_MAX, > > }, > > { > > .procname = "hung_task_check_count", > > diff --git a/lib/Kconfig.debug b/lib/Kconfig.debug index > > 3034e294..077b9e4 100644 > > --- a/lib/Kconfig.debug > > +++ b/lib/Kconfig.debug > > @@ -1258,12 +1258,14 @@ config DEFAULT_HUNG_TASK_TIMEOUT > > Keeping the default should be fine in most cases. > > > > config BOOTPARAM_HUNG_TASK_PANIC > > - bool "Panic (Reboot) On Hung Tasks" > > + int "Number of hung tasks to trigger kernel panic" > > depends on DETECT_HUNG_TASK > > + default 0 > > help > > - Say Y here to enable the kernel to panic on "hung tasks", > > - which are bugs that cause the kernel to leave a task stuck > > - in uninterruptible "D" state. > > + The number of hung tasks must be detected to trigger kernel panic. > > + > > + - 0: Don't trigger panic > > + - N: Panic when N hung tasks are detected > > + - N: Panic when N hung tasks are detected in a single scan > > With these documentation changes, this patch would accurately describe its > behavior, IMHO. > > > > > The panic can be used in combination with panic_timeout, > > to cause the system to reboot automatically after a diff --git > > a/tools/testing/selftests/wireguard/qemu/kernel.config > > b/tools/testing/selftests/wireguard/qemu/kernel.config > > index 936b18b..0504c11 100644 > > --- a/tools/testing/selftests/wireguard/qemu/kernel.config > > +++ b/tools/testing/selftests/wireguard/qemu/kernel.config > > @@ -81,7 +81,7 @@ CONFIG_WQ_WATCHDOG=y > > CONFIG_DETECT_HUNG_TASK=y > > CONFIG_BOOTPARAM_HARDLOCKUP_PANIC=y > > CONFIG_BOOTPARAM_SOFTLOCKUP_PANIC=y > > -CONFIG_BOOTPARAM_HUNG_TASK_PANIC=y > > +CONFIG_BOOTPARAM_HUNG_TASK_PANIC=1 > > CONFIG_PANIC_TIMEOUT=-1 > > CONFIG_STACKTRACE=y > > CONFIG_EARLY_PRINTK=y >