[PATCH] wifi: brcmsmac: Spelling corrections
Simon Horman <[email protected]>
| Newsgroups | dev.linux.lists.brcm80211,org.kernel.vger.linux-wireless |
|---|---|
| Message-ID | <[email protected]> |
Various spelling corrections as flagged by codespell. Signed-off-by: Simon Horman <[email protected]> --- drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.c | 6 +++--- drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.h | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/ampdu.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/channel.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/dma.c | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/mac80211_if.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.h | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/pmu.c | 2 +- 9 files changed, 15 insertions(+), 15 deletions(-) diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.c b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.c index 50d817485cf9..0cb64fc56783 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.c @@ -198,7 +198,7 @@ #define CST4313_SPROM_OTP_SEL_SHIFT 0 /* 4313 Chip specific ChipControl register bits */ - /* 12 mA drive strengh for later 4313 */ + /* 12 mA drive strength for later 4313 */ #define CCTRL_4313_12MA_LED_DRIVE 0x00000007 /* Manufacturer Ids */ @@ -453,7 +453,7 @@ ai_buscore_setup(struct si_info *sii, struct bcma_device *cc) /* get chipcommon chipstatus */ sii->chipst = bcma_read32(cc, CHIPCREGOFFS(chipstatus)); - /* get chipcommon capabilites */ + /* get chipcommon capabilities */ sii->pub.cccaps = bcma_read32(cc, CHIPCREGOFFS(capabilities)); /* get pmu rev and caps */ @@ -657,7 +657,7 @@ u16 ai_clkctl_fast_pwrup_delay(struct si_pub *sih) } /* - * clock control policy function throught chipcommon + * clock control policy function through chipcommon * * set dynamic clk control mode (forceslow, forcefast, dynamic) * returns true if we are forcing fast clock diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.h b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.h index 90b6e3982d2c..e791dd07ca78 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.h +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.h @@ -76,7 +76,7 @@ * conventions for the use the flash space: */ -/* Minumum amount of flash we support */ +/* Minimum amount of flash we support */ #define FLASH_MIN 0x00020000 /* Minimum flash size */ #define CC_SROM_OTP 0x800 /* SROM/OTP address space */ diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/ampdu.c b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/ampdu.c index a767cbb79185..e1d707a7c964 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/ampdu.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/ampdu.c @@ -479,7 +479,7 @@ void brcms_c_ampdu_reset_session(struct brcms_ampdu_session *session, /* * Preps the given packet for AMPDU based on the session data. If the - * frame cannot be accomodated in the current session, -ENOSPC is + * frame cannot be accommodated in the current session, -ENOSPC is * returned. */ int brcms_c_ampdu_add_frame(struct brcms_ampdu_session *session, @@ -529,7 +529,7 @@ int brcms_c_ampdu_add_frame(struct brcms_ampdu_session *session, } /* - * Now that we're sure this frame can be accomodated, update the + * Now that we're sure this frame can be accommodated, update the * session information. */ session->ampdu_len += len; diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/channel.c b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/channel.c index d1b9a18d0374..3878c4124e25 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/channel.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/channel.c @@ -445,7 +445,7 @@ brcms_c_channel_reg_limits(struct brcms_cm_info *wlc_cm, u16 chanspec, /* * OFDM 40 MHz SISO has the same power as the corresponding - * MCS0-7 rate unless overriden by the locale specific code. + * MCS0-7 rate unless overridden by the locale specific code. * We set this value to 0 as a flag (presumably 0 dBm isn't * a possibility) and then copy the MCS0-7 value to the 40 MHz * value if it wasn't explicitly set. @@ -479,7 +479,7 @@ brcms_c_channel_reg_limits(struct brcms_cm_info *wlc_cm, u16 chanspec, /* * 20 MHz has the same power as the corresponding OFDM rate - * unless overriden by the locale specific code. + * unless overridden by the locale specific code. */ txpwr->mcs_20_siso[i] = txpwr->ofdm[i]; txpwr->mcs_40_siso[i] = 0; diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/dma.c b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/dma.c index 80c35027787a..c739bf7463b3 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/dma.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/dma.c @@ -1348,7 +1348,7 @@ static void prep_ampdu_frame(struct dma_info *di, struct sk_buff *p) ret = brcms_c_ampdu_add_frame(session, p); if (ret == -ENOSPC) { /* - * AMPDU cannot accomodate this frame. Close out the in- + * AMPDU cannot accommodate this frame. Close out the in- * progress AMPDU session and start a new one. */ ampdu_finalize(di); diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/mac80211_if.c b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/mac80211_if.c index 5b1d35601bbd..1c3d29dca424 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/mac80211_if.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/mac80211_if.c @@ -48,9 +48,9 @@ FIF_BCN_PRBRESP_PROMISC | \ FIF_PSPOLL) -#define CHAN2GHZ(channel, freqency, chflags) { \ +#define CHAN2GHZ(channel, frequency, chflags) { \ .band = NL80211_BAND_2GHZ, \ - .center_freq = (freqency), \ + .center_freq = (frequency), \ .hw_value = (channel), \ .flags = chflags, \ .max_antenna_gain = 0, \ diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.c b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.c index 2738d4d6c60a..c1a9c1e442ee 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.c @@ -921,7 +921,7 @@ brcms_c_dotxstatus(struct brcms_c_info *wlc, struct tx_status *txs) * The "fallback limit" is the number of tx attempts a given * MPDU is sent at the "primary" rate. Tx attempts beyond that * limit are sent at the "secondary" rate. - * A 'short frame' does not exceed RTS treshold. + * A 'short frame' does not exceed RTS threshold. */ u16 sfbl, /* Short Frame Rate Fallback Limit */ lfbl, /* Long Frame Rate Fallback Limit */ @@ -6259,7 +6259,7 @@ brcms_c_d11hdrs_mac80211(struct brcms_c_info *wlc, struct ieee80211_hw *hw, } /* - * Currently only support same setting for primay and + * Currently only support same setting for primary and * fallback rates. Unify flags for each rate into a * single value for the frame */ diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.h b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.h index 9f76b880814e..b7ca0d9891c4 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.h +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.h @@ -603,7 +603,7 @@ enum brcms_bss_type { * cur_etheraddr: h/w address * flags: BSSCFG flags; see below * - * current_bss: BSS parms in ASSOCIATED state + * current_bss: BSS parameters in ASSOCIATED state * * * ID: 'unique' ID of this bsscfg, assigned at bsscfg allocation diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/pmu.c b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/pmu.c index 71b80381f3ad..c9a29e626daa 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/pmu.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/pmu.c @@ -31,7 +31,7 @@ #define EXT_ILP_HZ 32768 /* - * Duration for ILP clock frequency measurment in milliseconds + * Duration for ILP clock frequency measurement in milliseconds * * remark: 1000 must be an integer multiple of this duration */