Re: brcmfmac SAE/WPA3 negotiation - Part 2

KeithG <[email protected]>
Newsgroups dev.linux.lists.connman,dev.linux.lists.brcm80211,org.kernel.vger.linux-wireless
Message-ID <CAG17S_MfQ+FjWQJoiNs30rt4u1O9Z_FXFB7BiS6RAQsG9ReNkA@mail.gmail.com>
On Mon, Jan 6, 2025 at 9:26 AM Denis Kenzior <[email protected]> wrote:
>
> Hi Keith,
>
> On 1/5/25 6:41 PM, KeithG wrote:
> > I am looking at the iwmon logs for a successful wpa_supplicant
> > connection versus one from IWD. Both connect and both pass data and
> > both grab a DHCP address. I do note one difference in the connection,
> > though.
> >
> > Request : Connect
> > through the responses RTNL
> > wpa_supplicant knows it is dynamic
>
> wpa_supplicant doesn't manage network interfaces.  I assume you're using ConnMan
> for this? If so, ConnMan sets the IFF_DYNAMIC flag.  See
> https://git.kernel.org/pub/scm/network/connman/connman.git/tree/src/inet.c#n372
>
> >
> > Whereas the iwd log does not:
>
> iwd doesn't use IFF_DYNAMIC in its DHCP implementation at the moment.
>
> According to 'man netdevice':
>
>                IFF_DYNAMIC       The addresses are lost when the interface
>                                  goes down.
>
> I doubt this is the cause of your DHCP / connection problems.
>
> Regards,
> -Denis

Denis,

I am using connman to manage the connections. The connman config is
the same. The one iwmon snippet was with iwd masked and stopped but
wpa_supplicant installed and the connect performed in connmanctl. The
other is with wpa_supplicant removed and purged and iwd started,
running then restarted connman then initiated a connect form
connmanctl.

I pored over these logs yesterday and saw a few differences, but this
was one that stood out. I can look closer again tonight and see if I
notice anything else that I can summarize.

Keith
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.