WinDRBD 1.1.22 released

Dear WinDRBD community,

There is a new release of the WinDRBD 1.1 branch. The change is that
upon installing the WinDRBD driver the changes to the Windows registry
are flushed explicitly (namely in the windrbd install-bus-device/remove-bus-device
commands). This fixes some issues where the WinDRBD driver was reported
as not being installed, which could happen if the machine was reset shortly
after the WinDRBD installer has finished.

Note that since updates on Windows in general are not atomic you should
make sure that, while a WinDRBD installer (as also any other installer) is
running the machine, is not reset.

If you are not affected by the not installed after reset issue there is no
need to upgrade. Also the kernel module itself hasn't been changed
(except for the reported version number).

Best regards,

- Johannes