Re: [Fuego] How run Fuego tools on a Jenkins slave node

Hi

On Mon, Aug 30, 2021 at 7:54 PM <[email protected]> wrote:
>
>
>
> > -----Original Message-----
> > From: Michael Nazzareno Trimarchi <[email protected]>
> >
> > Hi
> >
> > On Mon, Aug 30, 2021 at 6:35 PM <[email protected]> wrote:
> > >
> > >
> > >
> > > > -----Original Message-----
> > > > From: Michael Nazzareno Trimarchi <[email protected]>
> > > >
> > > > Hi
> > > >
> > > > On Fri, Aug 27, 2021 at 11:10 PM <[email protected]> wrote:
> > > > >
> > > > >
> > > > >
> > > > > > -----Original Message-----
> > > > > > From: Michael Nazzareno Trimarchi <[email protected]>
> > > > > >
> > > > > > Hi
> > > > > >
> > > > > >
> > > > > > On Fri, Aug 27, 2021, 6:17 PM <[email protected] <mailto:[email protected]> > wrote:
> [...snipping a lot...]
> > >
> > > >
> > > > jenkins_master\->slave1 -> hw1,hw2
> > > >                         \->slave2 -> hw3
> > >
> > > Yes, but I would add a bit more detail here, for clarity:
> > >
> > > jenkins_master\->slave1\-> ftc -> docker ftc -> FUEGO_TRANSPORT -> hw1
> > >                                          \-> ftc -> docker ftc -> FUEGO_TRANSPORT -> hw2
> > >                           \-> slave2-> ftc -> docker ftc -> FUEGO_TRANSPORT -> hw3
> > >
> > > 90% of the time, FUEGO_TRANSPORT is ssh, but it could be some other protocol
> > > for executing commands on the board and transferring files (like 'serial', or 'ebf')
> > >
> >
> > Ok
> >
> > > Note that the call to 'docker ftc' is transparent.  On a system where Fuego is installed,
> > > you can just run 'ftc', and it figures our whether to run natively (if installed natively)
> > > or by doing a second invocation inside the container (if installed with a container).
> >
> > Ok, so I can clone it on my local node and use it
> >
>
> Yes.   And if hw4 happens to be the machine where all this is running, then you
> can use 'local' instead of 'ssh' as the Fuego transport for that 'board'.

I think that this is most of the use cases. In this cases the pipeline
result should be shown
import the html report and visualize in master. I think that this
should have a section on documentation.

I will ask someone in the company to play a bit. I'm always short in time

Michael

>  -- Tim
>


-- 
Michael Nazzareno Trimarchi
Co-Founder & Chief Executive Officer
M. +39 347 913 2170
[email protected]
__________________________________

Amarula Solutions BV
Joop Geesinkweg 125, 1114 AB, Amsterdam, NL
T. +31 (0)85 111 9172
[email protected]
www.amarulasolutions.com