Re: [PATCH 01/10 net-next v3] ipv6: convert CONFIG_IPV6 to built-in only and clean up Kconfigs

On 17/03/2026 15:00, Fernando Fernandez Mancera wrote:
> Maintaining a modular IPv6 stack offers image size savings for specific
> setups, this benefit is outweighed by the architectural burden it
> imposes on the subsystems on implementation and maintenance. Therefore,
> drop it.
> 
> Change CONFIG_IPV6 from tristate to bool. Remove all Kconfig
> dependencies across the tree that explicitly checked for IPV6=m. In
> addition, remove MODULE_DESCRIPTION(), MODULE_ALIAS(), MODULE_AUTHOR()
> and MODULE_LICENSE().
> 
> This is also replacing module_init() by device_initcall(). It is not
> possible to use fs_initcall() as IPv4 does because that creates a race
> condition on IPv6 addrconf.
> 
> Finally, modify the default configs from CONFIG_IPV6=m to CONFIG_IPV6=y
> except for m68k as according to the bloat-o-meter the image is
> increasing by 330KB~ and that isn't acceptable. Instead, disable IPv6 on
> this architecture by default. This is aligned with m68k RAM requirements
> and recommendations [1].
> 
> [1] http://www.linux-m68k.org/faq/ram.html
> 
> Signed-off-by: Fernando Fernandez Mancera <[email protected]>
> Tested-by: Ricardo B. Marlière <[email protected]>

That's a Kconfig/defconfig only patch, so build system. You cannot test
it in a meaning of testing code. Building code is not testing.

> Acked-by: Krzysztof Kozlowski <[email protected]>

You removed important parts of Ack. It was not provided like that.

Best regards,
Krzysztof