[PATCH 09/19] omfs: check for an inode write error with buffer_write_io_error()

__omfs_write_inode() spots a failed synchronous write, on both the primary
block and each mirror, by testing BH_Req together with !BH_Uptodate.  That
relies on the write completion handler clearing BH_Uptodate on error, which
this series removes: a buffer whose write failed still holds the data the
filesystem asked to be written, so declaring it not up to date is wrong and
makes callers re-read it.

BH_Write_EIO says exactly what this code wants to know, and it implies
BH_Req, so each pair collapses into one test.

No behaviour change today - a failed write sets BH_Write_EIO and clears
BH_Uptodate together.  It stops being a no-op at the end of the series,
where the new test is the one that still works.

Signed-off-by: Chao Shi <[email protected]>
---
 fs/omfs/inode.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/fs/omfs/inode.c b/fs/omfs/inode.c
index 1d915ef72119..bc37029a4afb 100644
--- a/fs/omfs/inode.c
+++ b/fs/omfs/inode.c
@@ -145,7 +145,7 @@ static int __omfs_write_inode(struct inode *inode, int wait)
 	mark_buffer_dirty(bh);
 	if (wait) {
 		sync_dirty_buffer(bh);
-		if (buffer_req(bh) && !buffer_uptodate(bh))
+		if (buffer_write_io_error(bh))
 			sync_failed = 1;
 	}
 
@@ -159,7 +159,7 @@ static int __omfs_write_inode(struct inode *inode, int wait)
 		mark_buffer_dirty(bh2);
 		if (wait) {
 			sync_dirty_buffer(bh2);
-			if (buffer_req(bh2) && !buffer_uptodate(bh2))
+			if (buffer_write_io_error(bh2))
 				sync_failed = 1;
 		}
 		brelse(bh2);
-- 
2.43.0