[PATCH v2 1/2] arm64: dts: qcom: qcs6490-rubikpi3: Add 3.3 V output supply
Hongyang Zhao <[email protected]>
| Newsgroups | dev.linux.lists.imx,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
Describe the GPIO-controlled VCC3V3_OUTPUT rail. This board-level rail supplies the two camera connectors and the 40-pin expansion header. Signed-off-by: Hongyang Zhao <[email protected]> --- .../boot/dts/qcom/qcs6490-thundercomm-rubikpi3.dts | 24 ++++++++++++++++++++++ 1 file changed, 24 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/qcs6490-thundercomm-rubikpi3.dts b/arch/arm64/boot/dts/qcom/qcs6490-thundercomm-rubikpi3.dts index d8a9a7e47bdc..45514918562b 100644 --- a/arch/arm64/boot/dts/qcom/qcs6490-thundercomm-rubikpi3.dts +++ b/arch/arm64/boot/dts/qcom/qcs6490-thundercomm-rubikpi3.dts @@ -214,6 +214,23 @@ vreg_usbhub_rest_1v8: regulator-usbhub-rest-1v8 { regulator-boot-on; }; + vreg_vcc3v3_output: regulator-vcc3v3-output { + compatible = "regulator-fixed"; + + regulator-name = "vcc3v3_output"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + + gpio = <&tlmm 14 GPIO_ACTIVE_HIGH>; + enable-active-high; + + pinctrl-0 = <&vcc3v3_output_en>; + pinctrl-names = "default"; + + regulator-always-on; + regulator-boot-on; + }; + vph_pwr: regulator-vph-pwr { compatible = "regulator-fixed"; @@ -1251,6 +1268,13 @@ usb_eth_power: usb-eth-power-state { bias-disable; }; + vcc3v3_output_en: vcc3v3-output-en-state { + pins = "gpio14"; + function = "gpio"; + drive-strength = <8>; + bias-disable; + }; + wifi_reset_active: wifi-reset-active-state { pins = "gpio16"; function = "gpio"; -- 2.43.0