[PATCH v2] power: supply: pf1550: enable charging when battery profile exists

From: Xu Rao <[email protected]>

PF1550 starts in charger mode 1, where charging is disabled. The driver
comment says that mode 2 should be selected for applications using a
battery, but the condition is inverted: PF1550_CHG_BAT_ON is written only
when power_supply_get_battery_info() fails.

Consequently, a board with a valid monitored-battery profile is left in
the default charger-off mode, while a board without battery information
enables charging with fallback settings.

Select mode 2 when battery information is available.

Fixes: 4b6b6433a97d ("power: supply: pf1550: add battery charger support")
Cc: [email protected]
Signed-off-by: Xu Rao <[email protected]>
---
Changes in v2:
- Drop power_supply_put_battery_info() calls because static battery
  profiles are not devm allocated.
- Leave the pre-existing handling of an unspecified constant charge
  voltage for a separate fix.

 drivers/power/supply/pf1550-charger.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/power/supply/pf1550-charger.c b/drivers/power/supply/pf1550-charger.c
index 41036f4cb64a..38cac156d2e6 100644
--- a/drivers/power/supply/pf1550-charger.c
+++ b/drivers/power/supply/pf1550-charger.c
@@ -514,7 +514,7 @@ static int pf1550_reg_init(struct pf1550_charger *chg)
 	 * a battery. The other supported mode is mode 2, the charger is turned
 	 * on to charge a battery when present.
 	 */
-	if (power_supply_get_battery_info(chg->charger, &info)) {
+	if (!power_supply_get_battery_info(chg->charger, &info)) {
 		ret = regmap_write(chg->pf1550->regmap,
 				   PF1550_CHARG_REG_CHG_OPER,
 				   PF1550_CHG_BAT_ON);
--
2.50.1