[PATCH v3 0/4] ARM: dts: vf: Iris carrier board for the Colibri VF50 and VF61

From: Mehmet Fide <[email protected]>

This adds a device tree for the Toradex Iris carrier board carrying the
Vybrid Colibri modules, plus two small preparatory patches for the
module-level dtsi that the i.MX Colibri variants already had.

Everything was tested on a Colibri VF50 on an Iris V1.1 running 6.18:
Ethernet, USB host and OTG, all three UARTs, i2c with the carrier RTC,
SPI, the microSD slot and the RS232 transceiver hogs.

Changes in v3, following Krzysztof's review:
- fold the Iris compatibles into the existing -on-eval enum entries
  instead of adding standalone entries
- use hyphens in the newly introduced compatibles
  (toradex,vf500-colibri-vf50-on-iris, toradex,vf610-colibri-vf61-on-iris)
- drop the fixed 5V regulator that only fed the VBUS regulator
- sent as a fresh thread instead of in reply to v2

Changes in v2:
- add the dt-bindings patch for the new compatibles
- describe the USB host VBUS regulator instead of hogging USBH_PEN

Mehmet Fide (4):
  ARM: dts: vf-colibri: apply the EXT_IO pin group
  ARM: dts: vf-colibri: name the SODIMM gpio lines
  dt-bindings: arm: fsl: add the Colibri VF50 and VF61 on Iris
  ARM: dts: vf: add Iris carrier board support for Colibri VF50 and VF61

 .../devicetree/bindings/arm/fsl.yaml          |  12 +-
 arch/arm/boot/dts/nxp/vf/Makefile             |   2 +
 arch/arm/boot/dts/nxp/vf/vf-colibri-iris.dtsi | 117 ++++++++++++++
 arch/arm/boot/dts/nxp/vf/vf-colibri.dtsi      | 153 ++++++++++++++++++
 .../boot/dts/nxp/vf/vf500-colibri-iris.dts    |  14 ++
 .../boot/dts/nxp/vf/vf610-colibri-iris.dts    |  14 ++
 6 files changed, 308 insertions(+), 4 deletions(-)
 create mode 100644 arch/arm/boot/dts/nxp/vf/vf-colibri-iris.dtsi
 create mode 100644 arch/arm/boot/dts/nxp/vf/vf500-colibri-iris.dts
 create mode 100644 arch/arm/boot/dts/nxp/vf/vf610-colibri-iris.dts


base-commit: 3d6d817622b0a9721e3cc404df3469171582be13
-- 
2.54.0