Re: [PATCH v4 1/9] KVM: TDX: Enable Notify VM exit

Binbin Wu <[email protected]>
Newsgroups dev.linux.lists.linux-coco,org.kernel.vger.kvm,org.kernel.vger.linux-kernel
Message-ID <[email protected]>
On 8/19/2026 5:48 PM, Xiaoyao Li wrote:
> Enable Notify VM exit functionality for TDX guests.
> 
> Notify VM exit is an existing feature supported by KVM.  Userspace can
> enable Notify VM exit through KVM_CAP_X86_NOTIFY_VMEXIT when it's
> reported as supported.  However, KVM reports the support of this CAP just
> based on the hardware capability but doesn't differentiate between VMX
> and TDX.  This leads to the issue that userspace can enable this cap for
> TDX guests without getting an error, but the feature is not actually
> enabled because KVM doesn't call the TDX module API to program the
> relevant TD VMCS fields.
> 
> Enable Notify VM exit for TDX guests by:
> 
>   - Invoking TDX module API calls to set NOTIFY_VM_EXITING and Notify
>     Window in TD VMCS.  It's done in tdx_vcpu_init() where other TD VMCS
>     bits are set.  Since TDX vCPU cannot be reset, it only needs to be
>     configured once when initializing the TDX vCPU.
> 
>   - Adding corresponding exit handler for TDX Notify VM Exit.
> 
> Notify VM exit can happen when executing the IRET instruction.  If the
> IRET unblocks the NMI blocking state, bit 12 of the exit qualification
> is set.  In this case, the VMM needs to restore the "blocked by NMI" state
> when it decides to re-enter the guest.  For TDX, KVM cannot manage the
> GUEST_INTERRUPTIBILITY_INFO and it's TDX module's responsibility to
> handle it.  Extract the common part without NMI blocking handling into a
> helper in common.h so that it can be shared between VMX and TDX.
> 
> Note, KVM uses "pre-production" terminology for the feature formally called
> Notify VM-Exit.  All public versions of the SDM refer to the feature as
> Instruction Timeout.  This will be remedied in the near future, for now,
> use KVM's terminology for consistency.
> 
> Note, #2, there is no enumeration bit for Notify VM exit by TDX module
> because all TDX modules support it, and allow to set the corresponding
> TD VMCS fields as long as the hardware supports the feature.
> 
> Fixes: 161d34609f9b ("KVM: TDX: Make TDX VM type supported")
> Cc: [email protected]
> Signed-off-by: Xiaoyao Li <[email protected]>
> Reviewed-by: Rick Edgecombe <[email protected]>
Reviewed-by: Binbin Wu <[email protected]>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.