[PATCH v2] Bluetooth: RFCOMM: validate skb length in MCC handlers

The RFCOMM MCC handlers cast skb->data to various protocol structs
without validating skb->len first. A malicious remote device can send
short MCC frames to trigger out-of-bounds reads in these handlers.

Fix this by using skb_pull_data() to safely validate and access the
required data in each handler. Return -EINVAL if the skb does not
contain enough data.

rfcomm_recv_rpn() requires special handling since 1-byte RPN requests
are valid per ETSI TS 07.10. Handle this by first pulling a single byte
for the DLCI field, and only validating the full struct when len > 1.

Also add a length check in rfcomm_recv_mcc() before accessing the MCC
header fields.

Fixes: 1da177e4c3f4 ("Linux-2.6.12-rc2")
Signed-off-by: SeungJu Cheon <[email protected]>
---
v2:
  - Use skb_pull_data() instead of manual length checks (Luiz)
  - Add a length check in rfcomm_recv_mcc() before accessing the MCC header (Paul)
  - Allow 1-byte RPN requests in rfcomm_recv_rpn() as per ETSI TS 07.10 (Paul)
---
 net/bluetooth/rfcomm/core.c | 66 ++++++++++++++++++++++++++++---------
 1 file changed, 50 insertions(+), 16 deletions(-)

diff --git a/net/bluetooth/rfcomm/core.c b/net/bluetooth/rfcomm/core.c
index 611a9a94151e..a2dfbff816d3 100644
--- a/net/bluetooth/rfcomm/core.c
+++ b/net/bluetooth/rfcomm/core.c
@@ -1431,10 +1431,15 @@ static int rfcomm_apply_pn(struct rfcomm_dlc *d, int cr, struct rfcomm_pn *pn)
 
 static int rfcomm_recv_pn(struct rfcomm_session *s, int cr, struct sk_buff *skb)
 {
-	struct rfcomm_pn *pn = (void *) skb->data;
+	struct rfcomm_pn *pn;
 	struct rfcomm_dlc *d;
-	u8 dlci = pn->dlci;
+	u8 dlci;
+
+	pn = skb_pull_data(skb, sizeof(*pn));
+	if (!pn)
+		return -EINVAL;
 
+	dlci = pn->dlci;
 	BT_DBG("session %p state %ld dlci %d", s, s->state, dlci);
 
 	if (!dlci)
@@ -1483,8 +1488,8 @@ static int rfcomm_recv_pn(struct rfcomm_session *s, int cr, struct sk_buff *skb)
 
 static int rfcomm_recv_rpn(struct rfcomm_session *s, int cr, int len, struct sk_buff *skb)
 {
-	struct rfcomm_rpn *rpn = (void *) skb->data;
-	u8 dlci = __get_dlci(rpn->dlci);
+	struct rfcomm_rpn *rpn;
+	u8 dlci;
 
 	u8 bit_rate  = 0;
 	u8 data_bits = 0;
@@ -1495,15 +1500,16 @@ static int rfcomm_recv_rpn(struct rfcomm_session *s, int cr, int len, struct sk_
 	u8 xoff_char = 0;
 	u16 rpn_mask = RFCOMM_RPN_PM_ALL;
 
-	BT_DBG("dlci %d cr %d len 0x%x bitr 0x%x line 0x%x flow 0x%x xonc 0x%x xoffc 0x%x pm 0x%x",
-		dlci, cr, len, rpn->bit_rate, rpn->line_settings, rpn->flow_ctrl,
-		rpn->xon_char, rpn->xoff_char, rpn->param_mask);
+	if (len == 1) {
+		rpn = skb_pull_data(skb, 1);
+		if (!rpn)
+			return -EINVAL;
 
-	if (!cr)
-		return 0;
+		dlci = __get_dlci(rpn->dlci);
+
+		if (!cr)
+			return 0;
 
-	if (len == 1) {
-		/* This is a request, return default (according to ETSI TS 07.10) settings */
 		bit_rate  = RFCOMM_RPN_BR_9600;
 		data_bits = RFCOMM_RPN_DATA_8;
 		stop_bits = RFCOMM_RPN_STOP_1;
@@ -1514,6 +1520,19 @@ static int rfcomm_recv_rpn(struct rfcomm_session *s, int cr, int len, struct sk_
 		goto rpn_out;
 	}
 
+	rpn = skb_pull_data(skb, sizeof(*rpn));
+	if (!rpn)
+		return -EINVAL;
+
+	dlci = __get_dlci(rpn->dlci);
+
+	BT_DBG("dlci %d cr %d len 0x%x bitr 0x%x line 0x%x flow 0x%x xonc 0x%x xoffc 0x%x pm 0x%x",
+		dlci, cr, len, rpn->bit_rate, rpn->line_settings, rpn->flow_ctrl,
+		rpn->xon_char, rpn->xoff_char, rpn->param_mask);
+
+	if (!cr)
+		return 0;
+
 	/* Check for sane values, ignore/accept bit_rate, 8 bits, 1 stop bit,
 	 * no parity, no flow control lines, normal XON/XOFF chars */
 
@@ -1589,9 +1608,14 @@ static int rfcomm_recv_rpn(struct rfcomm_session *s, int cr, int len, struct sk_
 
 static int rfcomm_recv_rls(struct rfcomm_session *s, int cr, struct sk_buff *skb)
 {
-	struct rfcomm_rls *rls = (void *) skb->data;
-	u8 dlci = __get_dlci(rls->dlci);
+	struct rfcomm_rls *rls;
+	u8 dlci;
+
+	rls = skb_pull_data(skb, sizeof(*rls));
+	if (!rls)
+		return -EINVAL;
 
+	dlci = __get_dlci(rls->dlci);
 	BT_DBG("dlci %d cr %d status 0x%x", dlci, cr, rls->status);
 
 	if (!cr)
@@ -1608,10 +1632,15 @@ static int rfcomm_recv_rls(struct rfcomm_session *s, int cr, struct sk_buff *skb
 
 static int rfcomm_recv_msc(struct rfcomm_session *s, int cr, struct sk_buff *skb)
 {
-	struct rfcomm_msc *msc = (void *) skb->data;
+	struct rfcomm_msc *msc;
 	struct rfcomm_dlc *d;
-	u8 dlci = __get_dlci(msc->dlci);
+	u8 dlci;
+
+	msc = skb_pull_data(skb, sizeof(*msc));
+	if (!msc)
+		return -EINVAL;
 
+	dlci = __get_dlci(msc->dlci);
 	BT_DBG("dlci %d cr %d v24 0x%x", dlci, cr, msc->v24_sig);
 
 	d = rfcomm_dlc_get(s, dlci);
@@ -1644,9 +1673,14 @@ static int rfcomm_recv_msc(struct rfcomm_session *s, int cr, struct sk_buff *skb
 
 static int rfcomm_recv_mcc(struct rfcomm_session *s, struct sk_buff *skb)
 {
-	struct rfcomm_mcc *mcc = (void *) skb->data;
+	struct rfcomm_mcc *mcc;
 	u8 type, cr, len;
 
+	if (skb->len < sizeof(*mcc))
+		return -EINVAL;
+
+	mcc = (void *) skb->data;
+
 	cr   = __test_cr(mcc->type);
 	type = __get_mcc_type(mcc->type);
 	len  = __get_mcc_len(mcc->len);
-- 
2.52.0