[PATCH v4 2/4] arm64: dts: allwinner: a523: add IR receiver nodes

The A523 has two CIR receivers, both compatible with the A31 CIR: one
in the CPUX domain, clocked from the main CCU, and one in the RTC
power domain, clocked from the R-CCU.

The RTC domain instance's RX signal is typically muxed to PL11, as on
the X96Q Pro+. The CPUX instance's can be muxed to PI8, which is what
the Avaota A1 uses.

Add nodes for both instances, disabled by default. Since the RX signal
of each instance can be routed to more than one pin, boards with an IR
receiver are expected to add the pinctrl properties next to where they
enable the node.

Add pinmux nodes for both pins: PL11 for the RTC domain instance, and
PI8 for the CPUX one.

Co-developed-by: Andre Przywara <[email protected]>
Signed-off-by: Andre Przywara <[email protected]>
Signed-off-by: Justin Suess <[email protected]>
---

Notes:

v4:
    - add /omit-if-no-ref/ and rename to r-ir-rx-pl-pin (Chen-Yu)
    - take the PI8 pinmux node from Andre's Avaota patch, named
      ir-rx-pi-pin (Chen-Yu); Co-developed-by added and Andre's
      Reviewed-by dropped, since the patch has a new hunk plus
      pinmux node name change.

 .../arm64/boot/dts/allwinner/sun55i-a523.dtsi | 36 +++++++++++++++++++
 1 file changed, 36 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi b/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
index ca6a16807049..f0b74693da7f 100644
--- a/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun55i-a523.dtsi
@@ -155,6 +155,13 @@ i2s2_pi_pins: i2s2-pi-pins {
 				bias-disable;
 			};
 
+			/omit-if-no-ref/
+			ir_rx_pin: ir-rx-pi-pin {
+				pins = "PI8";
+				allwinner,pinmux = <3>;
+				function = "cir_rx";
+			};
+
 			/omit-if-no-ref/
 			ledc_ph_pin: ledc-ph-pin {
 				pins = "PH19";
@@ -327,6 +334,17 @@ ccu: clock-controller@2001000 {
 			#reset-cells = <1>;
 		};
 
+		ir: ir@2005000 {
+			compatible = "allwinner,sun55i-a523-ir",
+				     "allwinner,sun6i-a31-ir";
+			reg = <0x02005000 0x400>;
+			interrupts = <GIC_SPI 27 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_IR_RX>, <&ccu CLK_IR_RX>;
+			clock-names = "apb", "ir";
+			resets = <&ccu RST_BUS_IR_RX>;
+			status = "disabled";
+		};
+
 		ledc: led-controller@2008000 {
 			compatible = "allwinner,sun55i-a523-ledc",
 				     "allwinner,sun50i-a100-ledc";
@@ -927,6 +945,24 @@ r_i2c_pins: r-i2c-pins {
 				allwinner,pinmux = <2>;
 				function = "r_i2c0";
 			};
+
+			/omit-if-no-ref/
+			r_ir_rx_pin: r-ir-rx-pl-pin {
+				pins = "PL11";
+				allwinner,pinmux = <2>;
+				function = "s_cir_rx";
+			};
+		};
+
+		r_ir: ir@7040000 {
+			compatible = "allwinner,sun55i-a523-ir",
+				     "allwinner,sun6i-a31-ir";
+			reg = <0x07040000 0x400>;
+			interrupts = <GIC_SPI 167 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&r_ccu CLK_BUS_R_IR_RX>, <&r_ccu CLK_R_IR_RX>;
+			clock-names = "apb", "ir";
+			resets = <&r_ccu RST_BUS_R_IR_RX>;
+			status = "disabled";
 		};
 
 		pck600: power-controller@7060000 {
-- 
2.54.0