Re: [PATCH v10 51/69] drm/bridge: ite-it6263: Advertise HDMI 1.3 capabilities

Thank you for your contribution! Sashiko AI review found 1 potential issue(=
s) to consider:
- [Low] The macro MAX_HDMI_TMDS_CHAR_RATE_HZ is left unused after its only =
caller was removed.
--

--- Patch [51]: [PATCH v10 51/69] drm/bridge: ite-it6263: Advertise HDMI 1.=
3 capabilities ---
commit bc899868425793b3c769c7eaa96a7d6bb7256b3c
Author: Cristian Ciocaltea <[email protected]>

drm/bridge: ite-it6263: Advertise HDMI 1.3 capabilities

This commit advertises HDMI 1.3 support for the IT6263 bridge and sets the
max_tmds_char_rate limit. It also drops the hdmi_tmds_char_rate_valid() hoo=
k=20
since its checks are now handled earlier by the DRM core.

> diff --git a/drivers/gpu/drm/bridge/ite-it6263.c b/drivers/gpu/drm/bridge=
/ite-it6263.c
> index 550999491086e..e8e0197171e10 100644
> --- a/drivers/gpu/drm/bridge/ite-it6263.c
> +++ b/drivers/gpu/drm/bridge/ite-it6263.c
[ ... ]
> @@ -738,20 +738,6 @@ it6263_bridge_atomic_get_input_bus_fmts(struct drm_b=
ridge *bridge,
>  	return input_fmts;
>  }
> =20
> -static enum drm_mode_status
> -it6263_hdmi_tmds_char_rate_valid(const struct drm_bridge *bridge,
> -				 const struct drm_display_mode *mode,
> -				 unsigned long long tmds_rate)
> -{
> -	if (mode->clock > MAX_PIXEL_CLOCK_KHZ)
> -		return MODE_CLOCK_HIGH;
> -
> -	if (tmds_rate > MAX_HDMI_TMDS_CHAR_RATE_HZ)
> -		return MODE_CLOCK_HIGH;

[Severity: Low]
Since this function is being removed, does this leave
MAX_HDMI_TMDS_CHAR_RATE_HZ as dead code?

Looking at drivers/gpu/drm/bridge/ite-it6263.c, the macro is defined near
the top of the file:

#define MAX_HDMI_TMDS_CHAR_RATE_HZ      225000000

but it doesn't appear to be used anywhere else in the driver now. Could it
be removed in this patch as well?

> -
> -	return MODE_OK;
> -}

--=20
Sashiko AI review =C2=B7 https://sashiko.dev/#/patchset/20260731-dw-hdmi-qp=
[email protected]?part=3D51