[PATCH 03/21] arm64: dts: allwinner: h616: add EMAC1 controller

From: Richard Genoud <[email protected]>

The H616 has a secondary EMAC controller that supports only RMII at
10/100 Mbps. It connects through PA0-PA9 to an EPHY in a companion
AC200 or AC300 package.

Add the EMAC1 controller and RMII pin group. Leave the controller
disabled for boards to enable when the companion Ethernet hardware
is present.

Signed-off-by: Richard Genoud <[email protected]>
Signed-off-by: James Hilliard <[email protected]>
---
 arch/arm64/boot/dts/allwinner/sun50i-h616.dtsi | 30 ++++++++++++++++++++++++++
 1 file changed, 30 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h616.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h616.dtsi
index 90fe56a1d3cd..6879f27c2b2b 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h616.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h616.dtsi
@@ -432,6 +432,14 @@ pwm5_pin: pwm5-pin {
 				function = "pwm5";
 			};
 
+			/omit-if-no-ref/
+			rmii_emac1_pins: rmii-emac1-pins {
+				pins = "PA0", "PA1", "PA2", "PA3", "PA4",
+					"PA5", "PA6", "PA7", "PA8", "PA9";
+				function = "emac1";
+				drive-strength = <40>;
+			};
+
 			/omit-if-no-ref/
 			spi0_pins: spi0-pins {
 				pins = "PC0", "PC2", "PC4";
@@ -789,6 +797,28 @@ mdio0: mdio {
 			};
 		};
 
+		emac1: ethernet@5030000 {
+			compatible = "allwinner,sun50i-h616-emac1";
+			reg = <0x05030000 0x10000>;
+			interrupts = <GIC_SPI 15 IRQ_TYPE_LEVEL_HIGH>;
+			interrupt-names = "macirq";
+			clocks = <&ccu CLK_BUS_EMAC1>;
+			clock-names = "stmmaceth";
+			resets = <&ccu RST_BUS_EMAC1>;
+			reset-names = "stmmaceth";
+			syscon = <&syscon>;
+			pinctrl-names = "default";
+			pinctrl-0 = <&rmii_emac1_pins>;
+			phy-mode = "rmii";
+			status = "disabled";
+
+			mdio1: mdio {
+				compatible = "snps,dwmac-mdio";
+				#address-cells = <1>;
+				#size-cells = <0>;
+			};
+		};
+
 		gpadc: adc@5070000 {
 			compatible = "allwinner,sun50i-h616-gpadc",
 				     "allwinner,sun20i-d1-gpadc";

-- 
2.53.0