[PATCH v3 0/5] thermal: loongson2: Add support for Loongson-2K0300 SoC
Binbin Zhou <[email protected]> Fri, 31 Jul 2026 17:42:16 +0800
| Newsgroups | dev.linux.lists.mfd,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-pm |
|---|---|
| Message-ID | <[email protected]> |
Hi all: This patch series adds thermal zone support for the Loongson-2K0300 SoC. The Loongson-2K0300's thermal sensor is generally compatible with the existing Loongson-2K series, but it features several key differences: 1. It has an independent CPU ID register for reading chip version information. 2. The raw temperature output field has been extended from 8 bits to 11 bits. 3. The temperature calculation formula has been updated to incorporate a correction factor based on the version information. To ensure robustness on older hardware revisions, a fallback mechanism is included: if the calculated temperature falls outside the valid range (-55 TO 125), the driver falls back to a simpler calculation and prints a warning. The patches have been validated on the Loongson-2K0300 development board. Thanks. Binbin ========= V3: Patch (2/5): - New patch for moving thermal_ops to chip_data; Patch (3/5): - Correct spelling errors; Patch (4/5): - Add Acked-by from Conor, thanks; Patch (5/5): - Keep loongson2_thermal_data->chip_data as const, and use data->flags as the private data. - Renmae LOONGSON2_THSENS_OUT_10B_MASK -> LOONGSON2_THSENS_OUT_11B_MASK; Link to V2: https://lore.kernel.org/all/[email protected]/ V2: Patch (1/4): - New patch form Sashiko; Patch (2/4): - New patch for adding chipid syscon compatible; Patch (3/4): - Use `loongson,chipid` phandle replace reg property; Patch (3/4): - Refact `calib_offset` calculate routing; - Add LS2K0300_OLD_FUSE_FLAG flag. Link to V1: https://lore.kernel.org/all/[email protected]/ Binbin Zhou (5): thermal/drivers/loongson2: Correct thermal sensor registration loop thermal/drivers/loongson2: Move thermal_ops to chip_data for SoC scalability dt-bindings: mfd: syscon: Allow syscon compatible for Loongson-2K0300 chip id dt-bindings: thermal: loongson,ls2k-thermal: Add compatible for Loongson-2K0300 thermal/drivers/loongson2: Add support for Loongson-2K0300 .../devicetree/bindings/mfd/syscon.yaml | 2 + .../thermal/loongson,ls2k-thermal.yaml | 73 +++++++++--- drivers/thermal/loongson2_thermal.c | 110 ++++++++++++++++-- 3 files changed, 157 insertions(+), 28 deletions(-) base-commit: 795f1b1a91ae13ebc012a364075e42f486a1cafe -- 2.52.0