Re: [PATCH 08/21] dt-bindings: mfd: x-powers: add AC200

Andrew Lunn <[email protected]> Mon, 3 Aug 2026 15:18:10 +0200

Newsgroups	dev.linux.lists.mfd,dev.linux.lists.linux-sunxi,org.infradead.lists.linux-arm-kernel,org.infradead.lists.linux-rockchip,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.netdev
Message-ID	<[email protected]>

> +            ethernet-phy-control {
> +                compatible = "x-powers,ac200-ephy-ctl";
> +                nvmem-cells = <&ephy_calibration>;
> +                nvmem-cell-names = "calibration";
> +                phy-mode = "rmii";
> +            };

What do you mean by an ethernet PHY control?

I assume this is not an actual Ethernet PHY, but some control logic
around it? Where is the ethernet PHY itself?

       Andrew