Re: [PATCH v3] mhi: host: Add standard elf image download functionality
Qiang Yu <[email protected]>
| Newsgroups | dev.linux.lists.mhi,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
On Wed, Dec 10, 2025 at 12:57:11AM +0200, Dmitry Baryshkov wrote: > On Sun, Dec 07, 2025 at 10:35:26PM -0800, Qiang Yu wrote: > > On Sat, Dec 06, 2025 at 01:25:34PM +0200, Dmitry Baryshkov wrote: > > > On Mon, Dec 01, 2025 at 06:33:15PM -0800, Qiang Yu wrote: > > > > From: Mayank Rana <[email protected]> > > > > > > > > Currently, the FBC image is a non-standard ELF file that contains a single > > > > ELF header, followed by segments for SBL, and WLAN FW. However, TME-L > > > > (Trust Management Engine Lite) supported devices (eg. QCC2072) requires > > > > separate ELF headers for SBL and WLAN FW segments due to TME-L image > > > > authentication requirement. > > > > > > > > Current image format contains two sections in a single binary: > > > > - First 512KB: ELF header + SBL segments > > > > - Remaining: WLAN FW segments > > > > > > > > The TME-L supported image format contains two sections with two elf > > > > headers in a single binary: > > > > - First 512KB: First ELF header + SBL segments > > > > - Remaining: Second ELF header + WLAN FW segments > > > > > > > > Download behavior: > > > > - Legacy: 1. First 512KB via BHI (ELF header + SBL) > > > > 2. Full image via BHIe > > > > > > > > - TME-L: 1. First 512KB via BHI (First ELF header + SBL) > > > > 2. Remaining via BHIe (Second ELF header + WLAN FW segments) > > > > > > > > Add standard_elf_image flag to mhi_controller_config to indicate TME-L > > > > supported image format. When set, MHI skips the first 512KB during WLAN FW > > > > download over BHIe as it is loaded in BHI phase. > > > > > > What is standard about it? > > > > The TME-L requires standard elf image format which includes single EFL > > header and WLAN FW segment. > > > > The "standard_elf_image" seems misleading. Since the new image format is > > required for TME-L image authentication, how about using > > tme_supported_image? > > Just elf_image? Is it too generic for this specific use case. Current image format also contains elf header. - Qiang Yu > > > > > > > > > > > > > > Reviewed-by: Baochen Qiang <[email protected]> > > > > Signed-off-by: Mayank Rana <[email protected]> > > > > Co-developed-by: Qiang Yu <[email protected]> > > > > Signed-off-by: Qiang Yu <[email protected]> > > > > --- > > > > Changes in v3: > > > > - Reword commit message. > > > > - Reword comments of standard_elf_image flag > > > > - Add reviewed-by tag. > > > > - Link to v2: https://lore.kernel.org/mhi/20250603-standard_elf_image_load_support-v2-1-cce97644e99e@oss.qualcomm.com/ > > > > > > > > Changes in v2: > > > > - V1 patch is paused because of no user. WLAN team plan to add support for > > > > new WLAN chip that requires this patch, so send v2. > > > > - Change author and SOB with new mail address. > > > > - Reword commit message. > > > > - Place standard_elf_image flag after wake_set in struct mhi_controller > > > > - Link to v1: https://lore.kernel.org/mhi/[email protected]/ > > > > --- > > > > drivers/bus/mhi/host/boot.c | 7 +++++++ > > > > include/linux/mhi.h | 4 ++++ > > > > 2 files changed, 11 insertions(+) > > > > > > > > diff --git a/drivers/bus/mhi/host/boot.c b/drivers/bus/mhi/host/boot.c > > > > index 205d83ac069f15a19ab2d66a63692e5d60334d4c..64fb7a257d3529167eddf1153d34cc6b25735809 100644 > > > > --- a/drivers/bus/mhi/host/boot.c > > > > +++ b/drivers/bus/mhi/host/boot.c > > > > @@ -584,6 +584,13 @@ void mhi_fw_load_handler(struct mhi_controller *mhi_cntrl) > > > > * device transitioning into MHI READY state > > > > */ > > > > if (fw_load_type == MHI_FW_LOAD_FBC) { > > > > + dev_dbg(dev, "standard_elf_image:%s\n", > > > > + (mhi_cntrl->standard_elf_image ? "True" : "False")); > > > > + if (mhi_cntrl->standard_elf_image) { > > > > + fw_data += mhi_cntrl->sbl_size; > > > > + fw_sz -= mhi_cntrl->sbl_size; > > > > + } > > > > + > > > > ret = mhi_alloc_bhie_table(mhi_cntrl, &mhi_cntrl->fbc_image, fw_sz); > > > > if (ret) { > > > > release_firmware(firmware); > > > > diff --git a/include/linux/mhi.h b/include/linux/mhi.h > > > > index dd372b0123a6da5107b807ff8fe940c567eb2030..a13106bb234d22e3876dff3c0d46f3dee1d9e05c 100644 > > > > --- a/include/linux/mhi.h > > > > +++ b/include/linux/mhi.h > > > > @@ -360,6 +360,9 @@ struct mhi_controller_config { > > > > * @bounce_buf: Use of bounce buffer > > > > * @fbc_download: MHI host needs to do complete image transfer (optional) > > > > * @wake_set: Device wakeup set flag > > > > + * @standard_elf_image: Flag to determine whether the first 512 KB of the FBC > > > > + * image need to be skipped when loading WLAN FW over > > > > + * BHIe interface (optional) > > > > > > How does the description correlate to the name of the flag? > > > > The description can be updated as: > > > > * @tme_supported_image: Flag indicating FBC image format supports TME-L > > * (Trust Management Engine Lite) authentication. > > * When set, skip first 512KB when loading WLAN FW > > * over BHIe interface (optional) > > > > > > > * @irq_flags: irq flags passed to request_irq (optional) > > > > * @mru: the default MRU for the MHI device > > > > * > > > > @@ -445,6 +448,7 @@ struct mhi_controller { > > > > bool bounce_buf; > > > > bool fbc_download; > > > > bool wake_set; > > > > + bool standard_elf_image; > > > > > > This flag is never set, making it a dead API. If there are other patches > > > setting up the flag, please include them into them in the same series. > > > > Let me discuss with Baochen about whether he can include the patch in his > > series that actually sets this flag for QCC2072 device. > > Otherwise it's a dead API which is generally not allowed. > > > > > - Qiang Yu > > > > > > > unsigned long irq_flags; > > > > u32 mru; > > > > }; > > > > > > > > --- > > > > base-commit: ac35e04f8000aaaf98635792464647e7a6f3422e > > > > change-id: 20251129-wlan_image_load_skip_512k-ddcfe49db8e3 > > > > > > > > Best regards, > > > > -- > > > > Qiang Yu <[email protected]> > > > > > > > > > > -- > > > With best wishes > > > Dmitry > > -- > With best wishes > Dmitry