[PATCH v3 1/2] gpu: nova-core: fix barrier usage in CPU->GSP messaging path

In the CPU->GSP messaging path, the code reads the read pointer from GSP,
writes the command, advances the write pointer, and then notifies the GSP.

A LOAD->STORE ordering is needed after reading the read pointer from GSP
and writing the command. Control dependency exists here which provide the
needed ordering, but it's best to avoid depending on it.

A STORE->STORE ordering is needed after the command write and before the
write pointer advance. This is currently incorrectly done after the write
pointer advance (and before GSP notification), but this can cause issue if
GSP is still processing ring buffer, as it may observe the write pointer
advance before command write. Thus move this barrier to be before the write
pointer advance. Note that barriers are not needed between write pointer
advance and GSP notification, as MMIO accessors already carries the
required barrier.

Signed-off-by: Gary Guo <[email protected]>
---
 drivers/gpu/nova-core/gsp/cmdq.rs | 15 ++++++++++++---
 1 file changed, 12 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/nova-core/gsp/cmdq.rs b/drivers/gpu/nova-core/gsp/cmdq.rs
index 6da728201281..70674d2d0f77 100644
--- a/drivers/gpu/nova-core/gsp/cmdq.rs
+++ b/drivers/gpu/nova-core/gsp/cmdq.rs
@@ -27,6 +27,11 @@
     ptr,
     sync::{
         aref::ARef,
+        barrier::{
+            dma_mb,
+            Full,
+            Write, //
+        },
         Mutex, //
     },
     time::Delta,
@@ -272,6 +277,10 @@ fn new(dev: &device::Device<device::Bound>) -> Result<Self> {
             (rx - 1, 0)
         };
 
+        // ORDERING: LOAD->STORE ordering needed to order `gsp_read_ptr` read before data write.
+        // Control dependency can serve the same purpose here, but we don't want to rely on it.
+        dma_mb(Full);
+
         // SAFETY:
         // - `data` was created from a valid pointer, and `rx` and `tx` are in the
         //   `0..MSGQ_NUM_PAGES` range per the invariants of `cpu_write_ptr` and `gsp_read_ptr`,
@@ -450,9 +459,6 @@ fn advance_cpu_write_ptr(&mut self, elem_count: u32) {
         let tx = io_project!(self.0, .cpuq.tx);
         let wptr = MsgqTxHeader::write_ptr(tx).wrapping_add(elem_count) % MSGQ_NUM_PAGES;
         MsgqTxHeader::set_write_ptr(tx, wptr);
-
-        // Ensure all command data is visible before triggering the GSP read.
-        fence(Ordering::SeqCst);
     }
 }
 
@@ -683,6 +689,9 @@ fn send_single_command<M>(&mut self, bar: Bar0<'_>, command: M) -> Result
             dst.header.length(),
         );
 
+        // ORDERING: STORE->STORE ordering needed to order `cpu_write_ptr` write after data write.
+        dma_mb(Write);
+
         // All set - update the write pointer and inform the GSP of the new command.
         let elem_count = dst.header.element_count();
         self.seq += 1;

-- 
2.54.0