Re: [PATCH v6 0/8] PCI: endpoint: pci-ep-msi: Add embedded doorbell fallback

On Thu, Feb 12, 2026 at 12:26:49PM +0900, Koichiro Den wrote:
> On Wed, Feb 11, 2026 at 05:52:53PM +0100, Niklas Cassel wrote:
> 
> Thanks for the additional context.
> Even if we introduce the distinction between BAR_RESERVED and BAR_DISABLED,
> as I understand it, we currently lack a way to describe what actually
> resides behind a BAR_RESERVED region.
> 
> Perhaps extending pci_epc_bar_desc to describe what a reserved BAR
> contains (e.g. DMA register block) might allow us to handle this in a
> cleaner and more generic way. It would at least be cleaner than treating it
> as a quirk and hard-code the reserved BAR+offset+contents.

Yes, you are absolutely right.

Improving struct pci_epc_bar_desc to be able give more information about a
BAR_RESERVED BAR would be a next logical step.

If we take RK3588 as an example:
BAR4 offset 0x0 is eDMA registers.
BAR4 offset 0x2000 is ATU registers.
BAR4 offset 0x4000 is MSI-X table.
BAR4 offset 0x5000 is MSI-X PBA.


Many different SoCs have the MSI-X table in one of the BARs.

pci-epf-test always puts the MSI-X table in BAR0 (test_reg_bar), after the
pci_epf_test_reg registers.

On RK3588, this mostly works fine, e.g. the MSI-X test case in the
pci_endpoint_test selftest passes with the MSI-X table in BAR0, however,
e.g. dw_pcie_ep_raise_msix_irq_doorbell() does not work when the MSI-X
table is in BAR0. If I hack the pci-epf-test code to have the MSI-X table
in BAR4 (as it is by default), then dw_pcie_ep_raise_msix_irq_doorbell()
works fine.


This would however require an EPF driver to be able to get an EPC drivers'
"desired" MSI-X table and MSI-X PBA location, so that it could call
pci_epc_set_msix() with these "desired" locations.


I guess we would just need to add a new "get desired MSI-X location" API
in epc->ops. However, I have been too busy to work on this, so right now it
is only an idea. (Anyone with some spare cycles are free to implement it.)

I know for a fact that many other SoCs with the DWC PCIe EP controller have
the MSI-X table in one of the BARs by default, so this would also allow
them to use dw_pcie_ep_raise_msix_irq_doorbell(). (And would also allow us
to no longer force disable these BAR_RESERVED BARs, as the PCI endpoint
currently has no way to make use for these BAR_RESERVED BARs.)


Kind regards,
Niklas