Re: [PATCH] qmi: Allow qmi_qmux_device_discover be called from callback

On Tuesday 30 July 2024 20:48:54 BST you wrote:
> Hi Adam,
> 
> > This certainly seems to improve the situation.  what happens now on boot
> > is
> > that the driver loads Ok, the UI shows the signal strength for a few
> > seconds, but then appears to go to an unregistered state, which is
> > supported by the logs below.  When I restart ofono, it seems to work
> > fine, this log is also below.
> 
>  From the first part of the log:
> Jul 30 10:44:40 PinePhone ofonod[2543]: src/gprs.c:registration_status_cb()
> / quectelqmi_0 error 0 status 1
> Jul 30 10:44:40 PinePhone ofonod[2543]:
> src/gprs.c:ofono_gprs_status_notify() /quectelqmi_0 status registered (1)
> ...
> Jul 30 10:44:40 PinePhone ofonod[2543]: src/
> network.c:ofono_netreg_status_notify() /quectelqmi_0 status 1 tech 7 lac
> 11016 ci -1
> 
> Looks like we're registered at this point.  Then:
> Jul 30 10:44:41 PinePhone ofonod[2543]:
> src/gprs.c:ofono_gprs_status_notify() /quectelqmi_0 status unregistered (0)
> ...
> Jul 30 10:44:57 PinePhone ofonod[2543]:
> src/gprs.c:ofono_gprs_status_notify() /quectelqmi_0 status unregistered (0)
> Jul 30 10:44:57 PinePhone ofonod[2543]: src/gprs.c:netreg_status_changed() 0
> (unregistered)
> 
> Then you restart oFono.  I'm not really sure why the firmware says it isn't
> registered?  You haven't observed this before on boot?
> 

Maybe it was a hiccup .. I just shutdown and booted, and its working fine this 
time. i'll keep an eye on it!

Since the service restart this morning, it appears to have been working fine 
all day.

> Regards,
> -Denis