[PATCH 6.1 257/303] i2c: bcm-iproc: remove printout on handled timeouts
Greg Kroah-Hartman <[email protected]>
| Newsgroups | dev.linux.lists.patches,org.kernel.vger.stable |
|---|---|
| Message-ID | <[email protected]> |
6.1-stable review patch. If anyone has any objections, please let me know. ------------------ From: Wolfram Sang <[email protected]> [ Upstream commit 796e2c260187e32530cf343546ba1cdf2e2f5491 ] I2C and SMBus timeouts are not something the user needs to be informed about on controller level. The client driver may know if that really is a problem and give more detailed information to the user. The controller should just pass this information upwards. Remove the printout. Signed-off-by: Wolfram Sang <[email protected]> Signed-off-by: Andi Shyti <[email protected]> Stable-dep-of: 98f2e9e6d6f9 ("i2c: iproc: reset bus after timeout if START_BUSY is stuck") Signed-off-by: Sasha Levin <[email protected]> Signed-off-by: Greg Kroah-Hartman <[email protected]> --- drivers/i2c/busses/i2c-bcm-iproc.c | 2 -- 1 file changed, 2 deletions(-) --- a/drivers/i2c/busses/i2c-bcm-iproc.c +++ b/drivers/i2c/busses/i2c-bcm-iproc.c @@ -811,8 +811,6 @@ static int bcm_iproc_i2c_xfer_wait(struc } if (!time_left && !iproc_i2c->xfer_is_done) { - dev_err(iproc_i2c->device, "transaction timed out\n"); - /* flush both TX/RX FIFOs */ val = BIT(M_FIFO_RX_FLUSH_SHIFT) | BIT(M_FIFO_TX_FLUSH_SHIFT); iproc_i2c_wr_reg(iproc_i2c, M_FIFO_CTRL_OFFSET, val);