Re: [PATCH v7 5/6] ARM: dts: zte: Add D-Link DWR-932M support

Linus Walleij <[email protected]> Tue, 5 May 2026 11:53:12 +0200

Newsgroups	dev.linux.lists.soc,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-doc,org.kernel.vger.linux-kernel,org.kernel.vger.linux-serial
Message-ID	<CAD++jL=PzwbKFvLDX_b-UvQtd83qfb+Kaeg1Oibo5mzRaFjR3Q@mail.gmail.com>

On Wed, Apr 29, 2026 at 9:14 PM Stefan Dösinger
<[email protected]> wrote:

> This adds base DT definition for zx297520v3 and one board that consumes it.
>
> The stock kernel does not use the armv7 timer, but it seems to work
> fine. The board has other board-specific timers that would need a driver
> and I see no reason to bother with them since the arm standard timer
> works.
>
> The caveat is the non-standard GIC setup needed to handle the timer's
> level-low PPI. This is the responsibility of the boot loader and
> documented in Documentation/arch/arm/zte/zx297520v3.rst.
>
> Signed-off-by: Stefan Dösinger <[email protected]>

Reviewed-by: Linus Walleij <[email protected]>

Yours,
Linus Walleij