[PATCH v2 15/19] ARM: mark RiscPC as deprecated

From: Arnd Bergmann <[email protected]>

This platform is the oldest still supported machine, dating back
to the original 1994 ARM610 version.  The only currently supported
configuration uses an ARMv4 StrongARM but still requires building
for ARMv3 because of the board design not supporting 16-bit
data access.

ARMv3 support has been removed in gcc-9, and the gcc-8 release
is already old but still supported for building the kernel.

The only set of machines that lacks support for 16-bit load/store
instructions (Alpha EV5 and older) was recently removed from
the kernel.

Since there is little hope of this being maintainable much
longer, plan to remove it in early 2027 while it is still expected
to mostly work.

Signed-off-by: Arnd Bergmann <[email protected]>
---
 arch/arm/mach-rpc/Kconfig | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/arch/arm/mach-rpc/Kconfig b/arch/arm/mach-rpc/Kconfig
index 55f6d829b677..60b3823b690c 100644
--- a/arch/arm/mach-rpc/Kconfig
+++ b/arch/arm/mach-rpc/Kconfig
@@ -1,5 +1,5 @@
 config ARCH_RPC
-	bool "RiscPC"
+	bool "RiscPC (DEPRECATED)"
 	depends on ARCH_MULTI_V4 && !(ARCH_MULTI_V4T || ARCH_MULTI_V5)
 	depends on !(ARCH_FOOTBRIDGE || ARCH_SA1100 || ARCH_MOXART || ARCH_GEMINI)
 	depends on !CC_IS_CLANG && GCC_VERSION < 90100 && GCC_VERSION >= 60000
@@ -19,3 +19,6 @@ config ARCH_RPC
 	help
 	  On the Acorn Risc-PC, Linux can support the internal IDE disk and
 	  CD-ROM interface, serial and parallel port, and the floppy drive.
+
+	  Support for these machines will go away in 2027,
+	  unless there are any remaining users that speak up.
-- 
2.39.5