[PATCH v3 0/3] irqchip/sg2042-msi: Set irq type according to DT configuration

From: Chen Wang <[email protected]>

Read the device tree configuration and then use it to set the
interrupt type.

This patchset is based on irq/drivers branch of tip.

---

Changes in v3:
  Thers is no major change in this version. Just adjust the order of the patches
  to change the DTs first. Thanks to Thomas for the suggestion.

Changes in v2:
  The patch series is based on irq/drivers branch of tip. You can simply review
  or test the patches at the link [2].

  Reverted the change to obtain params of "msi-ranges"; it's better not to
  assume the value of "#interrupt-cells" is 2, even though it's known to be
  the case. Thanks to Inochi for the comments.

Changes in v1:
  The patch series is based on irq/drivers branch of tip. You can simply review
  or test the patches at the link [1].

Link: https://lore.kernel.org/linux-riscv/[email protected]/ [1]
Link: https://lore.kernel.org/linux-riscv/[email protected]/ [2]
---

Chen Wang (3):
  riscv: sophgo: dts: sg2042: change msi irq type to
    IRQ_TYPE_EDGE_RISING
  riscv: sophgo: dts: sg2044: change msi irq type to
    IRQ_TYPE_EDGE_RISING
  irqchip/sg2042-msi: Set irq type according to DT configuration

 arch/riscv/boot/dts/sophgo/sg2042.dtsi | 2 +-
 arch/riscv/boot/dts/sophgo/sg2044.dtsi | 2 +-
 drivers/irqchip/irq-sg2042-msi.c       | 7 +++++--
 3 files changed, 7 insertions(+), 4 deletions(-)


base-commit: d36bf356068cdb5499b9bc458db9149c0fd938a2
-- 
2.34.1