Re: [PATCH v5 1/8] dt-bindings: net: qcom: document the ethqos device for SCMI-based systems
"Rob Herring (Arm)" <[email protected]>
| Newsgroups | dev.linux.lists.sophgo,dev.linux.lists.imx,dev.linux.lists.linux-sunxi,org.infradead.lists.linux-amlogic,org.infradead.lists.linux-riscv,org.infradead.lists.linux-rockchip,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.linux-mips,org.kernel.vger.linux-renesas-soc,org.kernel.vger.netdev |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 07 Nov 2025 11:29:51 +0100, Bartosz Golaszewski wrote: > From: Bartosz Golaszewski <[email protected]> > > Describe the firmware-managed variant of the QCom DesignWare MAC. As the > properties here differ a lot from the HLOS-managed variant, lets put it > in a separate file. Since we need to update the maximum number of power > domains, let's update existing bindings referencing the top-level > snps,dwmac.yaml and limit their maxItems for power-domains to 1. > > Signed-off-by: Bartosz Golaszewski <[email protected]> > --- > .../bindings/net/allwinner,sun7i-a20-gmac.yaml | 3 + > .../bindings/net/altr,socfpga-stmmac.yaml | 3 + > .../bindings/net/amlogic,meson-dwmac.yaml | 3 + > .../devicetree/bindings/net/eswin,eic7700-eth.yaml | 3 + > .../devicetree/bindings/net/intel,dwmac-plat.yaml | 3 + > .../bindings/net/loongson,ls1b-gmac.yaml | 3 + > .../bindings/net/loongson,ls1c-emac.yaml | 3 + > .../devicetree/bindings/net/nxp,dwmac-imx.yaml | 3 + > .../devicetree/bindings/net/nxp,lpc1850-dwmac.yaml | 3 + > .../devicetree/bindings/net/nxp,s32-dwmac.yaml | 3 + > .../devicetree/bindings/net/qcom,ethqos.yaml | 3 + > .../bindings/net/qcom,sa8255p-ethqos.yaml | 98 ++++++++++++++++++++++ > .../devicetree/bindings/net/renesas,rzn1-gmac.yaml | 3 + > .../bindings/net/renesas,rzv2h-gbeth.yaml | 3 + > .../devicetree/bindings/net/rockchip-dwmac.yaml | 3 + > .../devicetree/bindings/net/snps,dwmac.yaml | 5 +- > .../bindings/net/sophgo,cv1800b-dwmac.yaml | 3 + > .../bindings/net/sophgo,sg2044-dwmac.yaml | 3 + > .../bindings/net/starfive,jh7110-dwmac.yaml | 3 + > .../devicetree/bindings/net/stm32-dwmac.yaml | 3 + > .../devicetree/bindings/net/tesla,fsd-ethqos.yaml | 3 + > .../devicetree/bindings/net/thead,th1520-gmac.yaml | 3 + > .../bindings/net/toshiba,visconti-dwmac.yaml | 3 + > MAINTAINERS | 1 + > 24 files changed, 166 insertions(+), 1 deletion(-) > My bot found errors running 'make dt_binding_check' on your patch: yamllint warnings/errors: dtschema/dtc warnings/errors: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/qcom,sa8255p-ethqos.yaml: $id: Cannot determine base path from $id, relative path/filename doesn't match actual path or filename $id: http://devicetree.org/schemas/net/qcom,ethqos-scmi.yaml file: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/qcom,sa8255p-ethqos.yaml doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/[email protected] The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.