Re: [PATCH net-next v7 0/7] net: stmmac: qcom-ethqos: add support for SCMI power domains

On Fri, 2026-03-06 at 16:46 +0100, Bartosz Golaszewski wrote:
> Add support for the firmware-managed variant of the DesignWare MAC on
> the sa8255p platform. This series contains new DT bindings and driver
> changes required to support the MAC in the STMMAC driver.
> 
> It also reorganizes the ethqos code quite a bit to make the introduction
> of power domains into the driver a bit easier on the eye.
> 
> The DTS changes will go in separately.

As Jakub pointed out, it conflicts with the latest net-next, but does
apply cleanly on the latest mainline, so I tested there (on a SA8775P
board running the SCMI firmware).

The two NICs come up as expected. Basic iperf3 throughput and jitter
tests look good. I would offer a Tested-by tag and a summary of the
test results, but I think it's a moot point because you'll have to
submit a new version anyway.

I will wait for you to rebase, then test again and come back with the
results.

-- 
Best regards,
Radu