Re: [PATCH v4 0/5] Add initial Milk-V Duo S board support

Hi Joshua

On 3/28/26 6:34 PM, Joshua Milas wrote:
> This adds an initial device tree for the Milk-V Duo S board
> with support for reading from the SD card and network over
> Ethernet. This is continued work from Michael Opdenacker's
> v6 series [1] on the ARM64 and RISCV side. It has been tested
> with ARM64 and RISCV64 to boot from an SD card, have networking,
> and read I2C slave devices over i2c4.

I could test successfully on RISC-V, booting from MMC on a command line 
shell, and testing i2c4. However, I have an issue with Ethernet. When I 
add "ip=172.24.0.2" (for example) to the kernel command line, I'm 
getting this:

[    2.586984] stmmaceth 4070000.ethernet eth0: Register 
MEM_TYPE_PAGE_POOL RxQ-0
[    2.596428] stmmaceth 4070000.ethernet eth0: cannot attach to PHY 
(error: -ENODEV)
[    2.627351] IP-Config: Failed to open eth0
[    2.631859] IP-Config: No network devices available

However, "eth0" appears in the list of networking devices.
Does this work on your side?
Cheers
Michael.

-- 
Root Commit
Embedded Linux Training and Consulting
https://rootcommit.com