Re: [PATCH v3 04/16] PCI: dwc: layerscape-ep: Use cached PCIe capability offset
Frank Li <[email protected]>
| Newsgroups | dev.linux.lists.sophgo,dev.linux.lists.imx,dev.linux.lists.spacemit,org.infradead.lists.linux-amlogic,org.infradead.lists.linux-riscv,org.infradead.lists.linux-rockchip,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pci,org.kernel.vger.linux-tegra,org.ozlabs.lists.linuxppc-dev |
|---|---|
| Message-ID | <an4RrIcV2Q6NtQ1X@SMW015318> |
On Mon, Jul 20, 2026 at 11:06:07PM +0800, Hans Zhang wrote: > [You don't often get email from [email protected]. Learn why this is important at https://aka.ms/LearnAboutSenderIdentification ] > > Replace these with dw_pcie_get_pcie_cap(). The hardware is already enabled > by the driver before ls_pcie_ep_probe() and before the interrupt handler > runs. dw_pcie_get_pcie_cap() will cache the offset on first call, and > subsequent calls (including inside dw_pcie_ep_init) will use the cached > value without re-searching. > > Signed-off-by: Hans Zhang <[email protected]> > --- Reviewed-by: Frank Li <[email protected]> > In pci-layerscape-ep, dw_pcie_find_capability() is called in: > > ls_pcie_ep_probe() > -> offset = dw_pcie_find_capability() > -> pcie->lnkcap = dw_pcie_readl_dbi(offset + PCI_EXP_LNKCAP) > -> dw_pcie_ep_init() > -> ls_pcie_ep_interrupt_init() > -> devm_request_irq(..., ls_pcie_ep_event_handler) > -> ls_pcie_ep_event_handler() > -> dw_pcie_find_capability() > --- > drivers/pci/controller/dwc/pci-layerscape-ep.c | 9 +++------ > 1 file changed, 3 insertions(+), 6 deletions(-) > > diff --git a/drivers/pci/controller/dwc/pci-layerscape-ep.c b/drivers/pci/controller/dwc/pci-layerscape-ep.c > index 8936975ff104..b2d0b51df3c5 100644 > --- a/drivers/pci/controller/dwc/pci-layerscape-ep.c > +++ b/drivers/pci/controller/dwc/pci-layerscape-ep.c > @@ -74,7 +74,6 @@ static irqreturn_t ls_pcie_ep_event_handler(int irq, void *dev_id) > struct ls_pcie_ep *pcie = dev_id; > struct dw_pcie *pci = pcie->pci; > u32 val, cfg; > - u8 offset; > > val = ls_pcie_pf_lut_readl(pcie, PEX_PF0_PME_MES_DR); > ls_pcie_pf_lut_writel(pcie, PEX_PF0_PME_MES_DR, val); > @@ -83,9 +82,6 @@ static irqreturn_t ls_pcie_ep_event_handler(int irq, void *dev_id) > return IRQ_NONE; > > if (val & PEX_PF0_PME_MES_DR_LUD) { > - > - offset = dw_pcie_find_capability(pci, PCI_CAP_ID_EXP); > - > /* > * The values of the Maximum Link Width and Supported Link > * Speed from the Link Capabilities Register will be lost > @@ -93,7 +89,8 @@ static irqreturn_t ls_pcie_ep_event_handler(int irq, void *dev_id) > * that configured by the Reset Configuration Word (RCW). > */ > dw_pcie_dbi_ro_wr_en(pci); > - dw_pcie_writel_dbi(pci, offset + PCI_EXP_LNKCAP, pcie->lnkcap); > + dw_pcie_writel_dbi(pci, pci->pcie_cap + PCI_EXP_LNKCAP, > + pcie->lnkcap); > dw_pcie_dbi_ro_wr_dis(pci); > > cfg = ls_pcie_pf_lut_readl(pcie, PEX_PF0_CONFIG); > @@ -266,7 +263,7 @@ static int __init ls_pcie_ep_probe(struct platform_device *pdev) > > platform_set_drvdata(pdev, pcie); > > - offset = dw_pcie_find_capability(pci, PCI_CAP_ID_EXP); > + offset = dw_pcie_get_pcie_cap(pci); > pcie->lnkcap = dw_pcie_readl_dbi(pci, offset + PCI_EXP_LNKCAP); > > ret = dw_pcie_ep_init(&pci->ep); > -- > 2.34.1 > >