Re: [PATCH v2] riscv: mm: fix SWIOTLB initialization for systems with DRAM above 4GB

On Wed Apr 29, 2026 at 7:41 PM CST, Troy Mitchell wrote:
> On RISC-V platforms where the entire physical memory (DRAM) resides
> above the 32-bit address space (i.e., above dma32_phys_limit), the
> current SWIOTLB initialization logic fails.
>
> This patch addresses two interconnected issues on such platforms:
>
> 1. Incorrect 32-bit DMA bounce assumption:
> The existing condition `max_pfn > PFN_DOWN(dma32_phys_limit)` assumes
> that a 32-bit DMA bounce buffer is required simply because the maximum
> PFN exceeds the 32-bit limit. However, if all DRAM starts above 4GB,
> no memory exists below the limit to satisfy this allocation. Fix
> this by adding a check to ensure `memblock_start_of_DRAM()` is actually
> below the 32-bit limit before enforcing 32-bit SWIOTLB.
>
> 2. kmalloc() bounce buffer allocation failure on non-coherent systems:
> For non-coherent hardware, a bounce buffer is still mandatory for
> cache-line-aligned kmalloc(), even if 32-bit DMA bouncing is skipped.
> Without the `SWIOTLB_ANY` flag, swiotlb_init() defaults to allocating
> from low memory, which fails completely when DRAM only exists in high
> memory. By appending `SWIOTLB_ANY` to swiotlb_flags, the allocator is
> permitted to allocate this alignment buffer from high memory.
>
> With this patch, systems with non-coherent DMA and DRAM entirely above
> 4GB can successfully map the software IO TLB in high memory and boot
> normally.
>
> Tested-by: Anirudh Srinivasan <[email protected]>
> Signed-off-by: Troy Mitchell <[email protected]>
Just a gentle ping on this series. 

Please let me know if anyone has any feedback or if there is anything 
I should update.

                                  - Troy