[PATCH] thermal: spacemit: k1: disable hardware on driver remove

The driver uses devm_request_threaded_irq() but never disables the
hardware interrupt enable, sensor enable, or sensor power bits when
the driver is unbound.

Add a devm action that clears K1_TSENSOR_INT_EN_REG,
K1_TSENSOR_EN_ALL, and K1_TSENSOR_PCTRL_ENABLE on remove, mirroring
what k1_tsensor_init() sets up.

Signed-off-by: Pei Xiao <[email protected]>
---
 drivers/thermal/spacemit/k1_tsensor.c | 27 +++++++++++++++++++++++++++
 1 file changed, 27 insertions(+)

diff --git a/drivers/thermal/spacemit/k1_tsensor.c b/drivers/thermal/spacemit/k1_tsensor.c
index 79222d233129..cf79dc7d403f 100644
--- a/drivers/thermal/spacemit/k1_tsensor.c
+++ b/drivers/thermal/spacemit/k1_tsensor.c
@@ -199,6 +199,29 @@ static irqreturn_t k1_tsensor_irq_thread(int irq, void *data)
 	return IRQ_HANDLED;
 }
 
+static void k1_tsensor_shutdown(struct k1_tsensor *ts)
+{
+	u32 val;
+
+	/* Disable all interrupts */
+	writel(0xffffffff, ts->base + K1_TSENSOR_INT_EN_REG);
+
+	/* Disable all sensor */
+	val = readl(ts->base + K1_TSENSOR_EN_REG);
+	val &= ~K1_TSENSOR_EN_ALL;
+	writel(val, ts->base + K1_TSENSOR_EN_REG);
+
+	/* Power down the sensor module */
+	val = readl(ts->base + K1_TSENSOR_PCTRL_REG);
+	val &= ~K1_TSENSOR_PCTRL_ENABLE;
+	writel(val, ts->base + K1_TSENSOR_PCTRL_REG);
+}
+
+static void devm_k1_tsensor_shutdown(void *data)
+{
+	k1_tsensor_shutdown(data);
+}
+
 static int k1_tsensor_probe(struct platform_device *pdev)
 {
 	struct device *dev = &pdev->dev;
@@ -229,6 +252,10 @@ static int k1_tsensor_probe(struct platform_device *pdev)
 
 	k1_tsensor_init(ts);
 
+	ret = devm_add_action_or_reset(dev, devm_k1_tsensor_shutdown, ts);
+	if (ret)
+		return ret;
+
 	irq = platform_get_irq(pdev, 0);
 	if (irq < 0)
 		return irq;
-- 
2.25.1